Abstract:A full understanding of the material properties of skin tissue is crucial for exploring its tribo-mechanical behaviour. It has been widely accepted that the mechanical behaviour of skin tissue for both small and large deformations can be accurately described using a hyperelastic model, such as the one developed by Ogden. However, obtaining these Ogden parameters for in-vivo skin by in-vivo experiments no matter the indentation or suction tests is a significant challenge. The mathematical model used to describe the material behaviour during the test should consider not only the material nonlinearity but also the geometrical confinement of the tissue, the large deformations induced, and the fact that the specimens are relatively thin. A range of contact models is available to describe the contact behaviour during the indentation test. However, none of them can be used for hyperelastic materials with small thickness under large deformations. Simultaneously explaining material nonlinearity and geometric nonlinearity, either through theoretical equations or numerical calculations, poses a significant challenge. In this research, we propose a pragmatic method to obtain Ogden parameters for in-vivo skin tissue by combining experimental indentation results and numerical simulations. The indentation tests were used to obtain the force-indentation depth curves, while the numerical simulations were used to obtain the strain fields. The method assumes the material behaviour of specimens can be linearized in each small deformation increment, and the contact model developed by Hayes can be applied to accommodate each increment. Then, the linear elastic behaviour in each increment can be described by the elastic modulus E which were obtained using Hayes model, and the principal stresses in each increment were subsequently obtained using Hooke's law. By combining all stress fields, overall stress-strain curves can be constructed, from which the hyperelastic Ogden parameters can be obtained. A second numerical simulation of the hyperelastic indentation was then performed using the obtained Ogden parameters, allowing a comparison of the experimental and simulated relationships between force and indentation.

Automated analysis of soft hydrogel microindentation: Impact of various indentation parameters on the measurement of Young’s modulus

Automated analysis of soft material microindentation.

AFM Indentation and Material Property Identification of Soft Hydrogels

Macro-indentation testing of soft biological materials and assessment of hyper-elastic material models from inverse finite element analysis

Colloidal Probe Technique Optimization for Determination of Young's Modulus of Soft Adhesive Hydrogels

Micromechanical Properties of Polyacrylamide Hydrogels Measured by Spherical Nanoindentation

A Multi-Sphere Indentation Method to Determine Young's Modulus of Soft Polymeric Materials Based on the Johnson–Kendall–Roberts Contact Model

Measuring the elastic modulus of soft culture surfaces and three-dimensional hydrogels using atomic force microscopy

Micromechanical Indentation Platform for Rapid Analysis of Viscoelastic Biomolecular Hydrogels

A novel contact model for AFM indentation experiments on soft spherical cell-like particles.

Mechanical characterization of soft viscoelastic gels via indentation and optimization-based inverse finite element analysis

A Linear Fit for Atomic Force Microscopy Nanoindentation Experiments on Soft Samples

AFM Indentation on Highly Heterogeneous Materials Using Different Indenter Geometries

Influence of Friction in Material Characterization in Microindentation Measurement.

On the Determination of Elastic Moduli of Cells by AFM Based Indentation

A hybrid model to determine mechanical properties of soft polymers by nanoindentation

Determination of elastic moduli of polymeric materials using microhardness indentation

Development of a micro-indentation device for measuring the mechanical properties of soft materials

A New Method for Determining the Ogden Parameters of Soft Materials using Indentation Experiments

An indentation-based approach to determine the elastic constants of soft anisotropic tissues

Using the Adhesive Interaction Between Atomic Force Microscopy Tips and Polymer Surfaces to Measure the Elastic Modulus of Compliant Samples