Abstract:A full understanding of the material properties of skin tissue is crucial for exploring its tribo-mechanical behaviour. It has been widely accepted that the mechanical behaviour of skin tissue for both small and large deformations can be accurately described using a hyperelastic model, such as the one developed by Ogden. However, obtaining these Ogden parameters for in-vivo skin by in-vivo experiments no matter the indentation or suction tests is a significant challenge. The mathematical model used to describe the material behaviour during the test should consider not only the material nonlinearity but also the geometrical confinement of the tissue, the large deformations induced, and the fact that the specimens are relatively thin. A range of contact models is available to describe the contact behaviour during the indentation test. However, none of them can be used for hyperelastic materials with small thickness under large deformations. Simultaneously explaining material nonlinearity and geometric nonlinearity, either through theoretical equations or numerical calculations, poses a significant challenge. In this research, we propose a pragmatic method to obtain Ogden parameters for in-vivo skin tissue by combining experimental indentation results and numerical simulations. The indentation tests were used to obtain the force-indentation depth curves, while the numerical simulations were used to obtain the strain fields. The method assumes the material behaviour of specimens can be linearized in each small deformation increment, and the contact model developed by Hayes can be applied to accommodate each increment. Then, the linear elastic behaviour in each increment can be described by the elastic modulus E which were obtained using Hayes model, and the principal stresses in each increment were subsequently obtained using Hooke's law. By combining all stress fields, overall stress-strain curves can be constructed, from which the hyperelastic Ogden parameters can be obtained. A second numerical simulation of the hyperelastic indentation was then performed using the obtained Ogden parameters, allowing a comparison of the experimental and simulated relationships between force and indentation.

A hybrid model to determine mechanical properties of soft polymers by nanoindentation

A Multi-Sphere Indentation Method to Determine Young's Modulus of Soft Polymeric Materials Based on the Johnson–Kendall–Roberts Contact Model

Extracting viscoelastic properties of soft polymers from dynamic nanoindentation using an improved model

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

Identifying the Viscoelastic Properties of Soft Matter from the Indentation Response of a Hard Film-Soft Substrate System

Spherical Indentation Method for Determining the Constitutive Parameters of Hyperelastic Soft Materials

Extracting the isotropic uniaxial stress-strain relationship of hyperelastic soft materials based on new nonlinear indentation strain and stress measure

A novel contact model for AFM indentation experiments on soft spherical cell-like particles.

Determination of mechanical properties from sharp dynamic indentation

Determination of elastic moduli of polymeric materials using microhardness indentation

Development of a micro-indentation device for measuring the mechanical properties of soft materials

Automated analysis of soft material microindentation.

Using the Adhesive Interaction Between Atomic Force Microscopy Tips and Polymer Surfaces to Measure the Elastic Modulus of Compliant Samples

Relationship of Stiffness-Based Indentation Properties Using Continuous-Stiffness-Measurement Method

A Linear Fit for Atomic Force Microscopy Nanoindentation Experiments on Soft Samples

Determine the unique constitutive properties of elastoplastic materials from their plastic zone evolution under nanoindentation

Measuring the Young’s Relaxation Modulus of PDMS Using Stress Relaxation Nanoindentation

Elastic constants determination of anisotropic materials by depth-sensing indentation

A New Method for Determining the Ogden Parameters of Soft Materials using Indentation Experiments

Deep learning based nanoindentation method for evaluating mechanical properties of polymers

An Inverse Approach to Determine the Mechanical Properties of Elastoplastic Materials Using Indentation Tests