Interactions of the process parameters and mechanical properties of laser butt welds in thin high strength low alloy steel plates
Patricio Gustavo Riofrío,Carlos Alexandre Capela,José AM Ferreira,Amilcar Ramalho
DOI: https://doi.org/10.1177/1464420720910442
2020-03-17
Abstract:High strength low alloy steels subjected to the thermomechanical control process present excellent strength–toughness combination, high strength/weight ratio, and weldability. Therefore, they are widely used in structural components, such as pressure vessels, oil/gas transportation pipes, lifting equipment, vehicles, shipbuilding and offshore industries, and in the automotive industry where low thickness (0.8–3 mm thickness) is of great importance. Usually, these steels are welded by conventional gas metal arc welding, which creates wide heat-affected zones, large residual stresses, and distortion in the welded parts. Laser welding is nowadays an alternative process to weld high strength low alloy steel parts due to its advantages. The aim of this work is to understand the effect of process parameters on defects, weld bead geometry, microstructure, and mechanical properties, namely hardness and tensile strength. We identify the main laser welding parameters and their influence on the weld bead geometry and defects, for a 3 mm thick high strength low alloy steel welded under a maximum power of 2 kW. A cross section of the weld seam was optimized achieving a good geometry without porosity. The threshold value of the heat input to achieve complete penetration was determined for different focus diameters. The microstructure, size, and hardness of the heat-affected zone and of the fusion zone are strongly influenced by the heat input. The values of the tensile strength achieved in butt welds were close to the base metal by an appropriate selection of the laser welding parameters and the heat input.