Abstract:Given that many mines around the world are located in areas where fresh water is scarce, and companies are being held to increasingly stringent sustainability and environmental responsibility standards, many mines are looking to use locally available saline groundwater or seawater as mixing water in cemented paste backfill (CPB). However, the impacts of this decision on key engineering properties of CPB (e.g. strength and self-desiccation) that affect its mechanical stability need to be better understood to allow confident selection of this practical and more sustainable solution. Thus, the effect of mixing water salinity and binder type on the strength (unconfined compressive strength, UCS) development and self-desiccation (measured by suction and volumetric water content) of CPB is explored in this research. NaCl concentrations from 0 to 300 g/L were used in CPB made with silica tailings and Portland cement type I (PC). Concentrations of 10 and 35 g/L were found to moderately increase UCS, while a concentration of 100 g/L had comparable UCS to non-saline CPB and a concentration of 300 g/L was found to significantly decrease UCS over all curing times. The overall trend is 10 g/L > 35 g/L > 0 g/L > 100 g/L > 300 g/L. The UCS of the 60-day-old CPB with a NaCl of 300 g/L is significantly lower, registering a 26% decrease compared to the UCS of the 60-day-old CPB without salt. In contrast, the UCS of the 60-day-old CPBs containing 10 g/L and 35 g/L of salt exhibits a notable improvement, being 15% and 10% higher, respectively, than the UCS of the 60-day-old CPB without salt. Water content and suction monitoring were conducted up to 28 days of curing time, and it was found that suction only slightly contributed to UCS gain of the saline CPB, and high salt contents (100 and 300 g/L) significantly inhibited the self-desiccation ability of CPB due to inhibition of cement hydration by the excessive amount of salt. The increase in strength of both saline and non-saline samples was attributed primarily to the increase in cement hydration products, while the increased strength of the samples with salinities of 10 and 35 g/L was mainly attributed to the enhancement of the binder hydration due to the low amount of salt and the presence of Friedel’s salt in the pores. The effect of PC replacement by 25 to 75% with slag on CPB with 35 g/L mixing water salinity was also studied. Slag replacement of 50% and higher resulted in significantly higher UCS over most curing times. Suction likely moderately contributed to UCS of the saline CPB with slag, in addition to the presence of Friedel’s salt in the pores and the acceleration of cement and slag hydration by the presence of NaCl.

Effect of Salinity on Strength Behavior of Cement-treated Dredged Clay at High Initial Water Contents

Effects of Natural Seawater and Sea Sand on the Compressive Behaviour of Unconfined and Carbon Fibre-Reinforced Polymer-Confined Concrete

Effect of Salinity on Rheological Behavior of Cement-Treated Dredged Clays as Fills

Fundamental Mechanical Behavior of CMMOSC-S-C Composite Stabilized Marine Soft Clay

Investigation on strength characteristics of fly ash treated dredged marine clay with various pore water salinities

Strength estimation of cement-treated marine dredged clay under a wide range of water-to-cement ratio

Degradation effect of seawater on the long-term dynamic behavior of artificially cemented sand

Strength development and self-desiccation of saline cemented paste backfill

Mechanical characteristic and microstructure of salt-rich cement soil

Effects of Cyclic Seawater Exposure on the Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete

Experimental Study on Engineering Properties of Cemented Soil with High Water Content

Deterioration Effect of Soil-cement Pile Under Saltwater Environment and Its Influence on Composite Foundation Settlement of Road

Experimental study on the strength, collapsibility, and microstructure of cement and micro-silica-stabilized saline soil under freeze-thaw cycles

Pore fluid salinity effects on post-stabilization performance of cement-treated Marl

Unconfined Compressive Strength of Cement-Stabilized Qiantang River Silty Clay

An Experimental Study on Relationship among Water Sorptivity, Pore Characteristics, and Salt Concentration in Concrete

Chloride Ingress Profiles and Binding Capacity of Mortar in Cyclic Drying-Wetting Salt Fog Environments

Effects of metakaolin and sodium silicate treatment on highwater content dredged clay for improved construction fill performance

Study on unconfined compressive strength and deformation characteristics of chlorine saline soil

Study on mechanical properties of dredged silt stabilized with cement and reinforced with alginate fibers

Distinguishing the effects of cementation versus density on the mechanical behavior of cement-based stabilized clays