Abstract:<p>There is a need for decarbonization in power generation and transportation. Natural gas can replace conventional petroleum fuels due to its low carbon-to-hydrogen ratio, especially in existing diesel engines. This paper was based on the hypothesis that "ideal" natural gas engines would operate both stoichiometric and lean, as needed. Therefore, the need to identify the effect of leaning the mixture on several parameters not usually shown in the literature. This paper compared the performance and emissions of a heavy-duty diesel engine converted to natural gas spark ignition operation under stoichiometric (equivalence ratio, ϕ = 1.0) and lean (ϕ = 0.8) operation. The original cylinder head and piston were maintained, and no exhaust gas recirculation was used. The results showed that lean operation decreased peak cylinder pressure and maximum pressure rise rate by 10–15% and 1 bar/°CA, respectively, and increased the volumetric efficiency from ~72% to ~74%. While it also increased the ignition lag, which translated in up to 5°CA delay in the location of peak pressure and crank angle associated with 50% of energy release at the same spark timing and a ~ 5°CA advance in the location of maximum indicated mean effective pressure, it had a negligible effect on the combustion duration due to distinguishing characteristics of gas and flame motion in the bowl-in-piston chamber. Lean operation increased unburned hydrocarbon and nitrogen oxides emissions by up to 15% and 300%, respectively, and carbon monoxide emissions were ~ 20× lower. Lean operation improved indicated thermal efficiency by two percentage points due to a 15% decrease in the heat losses but decreased the exhaust temperature by ~ 50 °C, which would affect the aftertreatment performance. Stoichiometric operation reduced the combustion fluctuations. However, the increased turbulence inside the "fast-burn" bowl-in-piston chamber compensated for the lower natural gas flame speed, with a variation of the indicated mean effective pressure below 2.5% even at ϕ = 0.8. Finally, important differences were observed compared to a traditional spark ignition engine. For example, diesel engine conversation increased nitrogen oxides emissions under lean burn but lowered unburned hydrocarbon and carbon oxide emissions when retarding spark timing from the optimum value. These findings suggest that more studies are needed to better understand the optimization of dedicated natural gas engines converted from diesel, under both lean and stoichiometric operations.</p>

Effect of Natural Gas Composition on Low Nox Burners Operation in Heavy Duty Gas Turbine

Optical and Numerical Investigations of Flame Propagation in a Heavy Duty Spark Ignited Natural Gas Engine

Observation of Flame Propagation in a Heavy-Duty Natural-Gas Lean Burn Spark-Ignition Engine

Numerical Investigation of Methane Number and Wobbe Index Effects in Lean-Burn Natural Gas Spark-Ignition Combustion

Effect of Bowl-in-Piston Chamber on the Combustion Process in a Stoichiometric Natural-Gas Spark-Ignition Engine

Lessons from the Conversion of a Heavy-Duty Compression Ignition Engine to Natural Gas Spark Ignition Operation

Experimental and Numerical Investigations of Novel Natural Gas Low NOx Burners for Heavy Duty Gas Turbine

An Experimental Study of the Combustion Process in a Natural-Gas Spark-Ignition Engine

Combustion Diagnostics and Emissions Measurements of a Novel Low Nox Burner for Industrial Gas Turbine Operated with Co2 Diluted Methane/Air Mixtures

Study on combustion and emission characteristics of a heavy-duty gas turbine combustor fueled with natural gas

Numerical Studies of a Water-cooled Premixed Burner for Low NOx Combustion of Natural Gas

Effect of Burner Structural Parameters on Combustion Characteristics and NOx Emission of Natural Gas

Design Improvement Survey for NOx Emissions Reduction of a Heavy-Duty Gas Turbine Partially Premixed Fuel Nozzle Operating With Natural Gas: Numerical Assessment

Numerical Studies of a Water-cooled Premixed Burner for Low NO x Combustion of Natural Gas

Experimental investigation of a heavy-duty natural gas engine performance operated at stoichiometric and lean operations

Research: influence of air classification ratio on low nitrogen performance of natural gas burner

Study on the Flame Transition Characteristics of a Gas Turbine Combustor

Combustion Instabilities Damping System Development for Dry Low NOx Emissions Operability Enhancement of a Heavy-Duty Gas Turbine

Experimental Investigation of the Combustion Behavior of Single-Nozzle Liquid-FLOX®-Based Burners on an Atmospheric Test Rig

NUMERICAL SIMULATION OF COMBUSTION OF NATURAL GAS WITH HIGH-TEMPERATURE AIR

Experimental And Cfd Evaluation Of The Part Load Performance Of A Micro Gas Turbine Fuelled With Ch4-N-2 Mixtures