Abstract:The surface tension of liquids is an important parameter to characterize the properties of liquids. The non-contact method of measuring the surface tension coefficient of liquids has the advantages of being fast, non-destructive, simple and practical. A new non-contact method for measuring the surface tension coefficient of transparent liquid based on the theory of light propagation is developed, and a special phenomenon of "self-interference" is discovered. The "Phase Standing Wave" theory is proposed to explain the phenomenon.The surface wave of the liquid is excited by a frequency-adjustable vibration source (oscillator), and it propagates dynamically in the form of oscillator and cosine wave. When the white light source or laser is incident on the liquid surface obliquely, the phase distribution (cosine-like wave) generated by the light wave carrying the surface wave is first incident on the white paper which locates at the bottom of the liquid, and the oscillator will also form the oscillator shadow on the white paper. The phase distribution of the light wave on the white paper spreads around dynamically in the form of cosine wave centering on the oscillator shadow. After diffuse reflection from the white paper, part of the diffuse reflected light in the observation direction will carry the dynamic phase generated by the surface wave for the first time back to the liquid surface and meets the surface wave again. After the light wave passes through the surface, it will carry the phase generated by the surface wave twice, that is, the superposition of two surface waves occurs in the phase of the light wave. In the phase of the light wave, the phase wave of the oscillator will propagate in the direction of the oscillator shadow, and the phase wave of the oscillator shadow will propagate in the direction of the oscillator.According to the conditions of the formation of standing waves, two surface waves propagating in the opposite direction can form standing waves, so the phase standing waves can only exist within a relatively small range between the oscillator and the oscillator shadow. Thus the dark and bright "Self-interference" with stable stripes can be observed in the far field. When white light and laser are used as light sources respectively, the fringe spacing remains unchanged, indicating that the fringe spacing is independent of the wavelength of incident light, and the light wave is only the carrier of the mechanical wave phase. The light wave with different wavelength and coherence has no influence on the experimental measurement results.The fringe spacing is measured automatically by analyzing and processing the image captured by camera. According to the dispersion relationship of surface waves, the surface tension coefficient of water is obtained automatically and accurately. The experimental setup is simple, easy to operate, the experimental phenomenon is intuitive, the stripes are clear and stable, and the anti-interference capability is strong, and can be observed in all directions. It can be widely applied to measure the surface tension coefficient of other transparent liquids.

Visible Light Backscattering Monitored in Situ for Transitional Phase Inversion of BrijL4–Isopropyl Myristate–Water Emulsions

Cone–Plate Rheometer as Reactor and Viscosity Probe for the Detection of Transitional Phase Inversion of Brij30–Isopropyl Myristate–Water Model Emulsion

Polymerization-induced viscoelastic phase separation in polyethersulfone-modified epoxy systems.

Identification of the Catastrophic Phase Inversion Point of Water-in-Oil Emulsion Using Ultrasonic Measurements

Phase Inversions Observed in Thermoresponsive Pickering Emulsions Stabilized by Surface Functionalized Colloidal Silica

Measuring the Surface tension coefficient of liquids by “Phase standing wave” method

Evolution of oil/water interface in the presence of SDBS detected by dual polarization interferometry

Monitoring of Antisolvent Crystallization of Sodium Scutellarein by Combined FBRM–PVM–NIR

Optimization of Oil-in-Water Emulsion Stability: Experimental Design, Multiple Light Scattering, and Acoustic Attenuation Spectroscopy

Effect of Equilibration Time on the Structural Gradient in the Vertical Direction for Bicontinuous Microemulsions in Winsor-III and -IV Systems

Measuring the Electro-Optical Kerr Effect Against the Background of Electro-Absorption Modulation in Liquids

Speed of Sound Measurement and Mapping in Transparent Materials by Impulsive Stimulated Brillouin Microscopy

Comprehensive Evaluation of Tilted Fiber Bragg Grating (TFBG) Sensors for Characterizing Oil–Water Emulsions: A Study on the Impact of Surfactant Concentration and Mixing Speed

In-Situ Imaging of a Light-Induced Modification Process in Organo-Silica Films via Time-Domain Brillouin Scattering

Identifying High-Performance EOR Surfactants Through Non-Destructive Evaluation of the Phase Behavior Microstructure

Multi-Parameter Characterization of Liquid-to-Ice Phase Transition Using Bulk Acoustic Waves

Infrared Spectroscopy of Bilberry Extract Water-in-Oil Emulsions: Sensing the Water-Oil Interface

Use of a rugged mid-infrared spectrometer for in situ process analysis of liquids

Direct observation of the formation and destruction of the inverted continuous oil phase in the micro-outlet region achieved by the confined diluted O/W emulsion stream.

Solid-Liquid-Liquid Wettability of Surfactant-Oil-Water Systems and Its Prediction around the Phase Inversion Point

Real-Time Analysis of the Stability of Oil-In-Water Pickering Emulsion by Electrochemical Impedance Spectroscopy