Abstract:Summary Spontaneous imbibition can help to improve the oil recovery of unconventional reservoirs owing to the significant capillarity. Although the dependence of imbibition dynamics of surfactants on wettability and interfacial tension (IFT) is understood, the mechanisms of nanoemulsion and microemulsion forming surfactants for higher imbibition recovery are not as clear. Herein, we conducted a series of imbibition experiments on a visual fracture-matrix micromodel, aiming to directly observe the imbibition processes of these surfactant formulations. Four surfactant-based fluids, including a common surfactant [fatty alcohol polyoxyethylene ether, sodium sulfate (AES)], a surfactant composition of nanoemulsion (nE-S), an ex-situ nanoemulsion (nE), and a situ microemulsion forming surfactant (mE-FS), were designed and used in this work for comparison with brine. The results suggested that AES, nE-S, nE, and mE-FS could substantially stimulate the imbibition invasion, and mE-FS generated the greatest imbibition depth and sweeping area followed by nE. The imbibition dynamics were governed by the interfacial interactions among oil, aqueous phase, and solid surface, leading to different imbibition patterns for these five fluids. AES and nE-S could reduce the oil-aqueous IFT to 10−1 mN/m and alter the wettability to a weak water-wet state as a result of surfactant adsorption, leading to a slightly higher imbibition invasion compared with brine. AES imbibition produced large oil droplets mainly because of the snap-off effect at the nozzle to the fracture, whereas nE-S produced smaller oil droplets due to the weak in-situ emulsification. nE as a formed nanoemulsion with an internal oil phase demonstrated a lower IFT of 10−2 mN/m and superior capacity in changing surface wettability mainly through the adsorption and spreading of nanosized oil droplets on the surface. The oil phase was heavily emulsified forming dense droplets on the oil-aqueous interface. mE-FS readily formed Winsor Type III microemulsion and produced an IFT of 10−3 mN/m magnitude. The wettability was changed mainly because of the peeling oil film and formation of microemulsion on the surface induced by solubilization. The dynamic increase of the oil-aqueous IFT at the imbibition front caused by the adsorption loss of surfactant to the surface and partitioning to the oil phase promoted capillary-driven imbibition for nE and mE-FS. We modified an imbibition model to incorporate the solubilization effect, leading to a much better fitting with the experimental data.

Solid-Liquid-Liquid Wettability of Surfactant-Oil-Water Systems and Its Prediction around the Phase Inversion Point

Isopiestic determination of the water activities and prediction of liquid–liquid equilibrium in polyethylene glycol+hydroxypropyl starch+water systems

Using energy balance to determine pore-scale wettability

A thermodynamically consistent characterization of wettability in porous media using high-resolution imaging.

Evolution of oil/water interface in the presence of SDBS detected by dual polarization interferometry

Wettability Characterization from Pore-Scale Images Using Topology and Energy Balance with Implications for Recovery and Storage

Determination of contact angles for three-phase flow in porous media using an energy balance

Reentrant Wetting Transition On Surfactant Solution Surfaces

Liquid-Liquid Phase Equilibria and Interactions Between Droplets in Water-In-Oil Microemulsions

Surfactant-dependent critical interfacial tension in silicon carbide membranes for produced water treatment

Effects of Surface Wettability on Contact Line Motion in Liquid–liquid Displacement

In-Situ Visualization of Imbibition Process Using a Fracture-Matrix Micromodel: Effect of Surfactant Formulations toward Nanoemulsion and Microemulsion

Dynamic Contact Angle Reformulates Pore-Scale Fluid-Fluid Displacement at Ultralow Interfacial Tension

Liquid-liquid Phase Equilibrium and the Effect of a Water-Soluble Polymer on the Interaction Between Droplets in Water-in-oil Microemulsions

Rapid design and optimization of complex surfactant microemulsions for high-efficiency oil extraction processes integrating experimental and modeling approaches

The Prediction of Intrinsic Wettability without Young's Equation

Modeling Dynamic Surface Tension on Surfactant-Enhanced Polydimethylsiloxane

An Equivalent Surface Model Bridging Intermolecular Interactions and the Normalization of Substrate Wettability

Emulsification mechanism of surfactants in different oil phases: A dissipative particle dynamics study

Surface Wetting Study via Pseudocontinuum Modeling

Surfactant-induced wetting transitions: Role of surface hydrophobicity and effect on oil permeability of ultrafiltration membranes