Abstract:Heat and mass transport during drop impact or a gentle deposition onto a heated substrate depends on the surface chemistry, morphology, thermal and mechanical properties of the substrate, as well as the substrate temperature. In particular, if a substrate is coated with a porous layer of a wettable material, the drop spreading is accompanied by the imbibition of a liquid into the layer. The wetted area is significantly enhanced in comparison with the area which can be covered by a drop spreading over a bare substrate. As a result, the liquid evaporation rate increases and the evaporation time decreases. Understanding the interaction between the liquid spreading, imbibition and evaporation is important, both for enhancement of heat transfer in cooling applications and for functionalizing of porous media. In our experimental studies, a disk of infrared-transparent calcium fluoride is used as the base substrate. The disk is coated with a submicrometer layer of black chromium nitride and an electrically conductive chromium layer, used for heating of the substrate by electrical current. Nanofiber coating layers are applied on top of the chromium layer using electrospinning. The dynamics of drop spreading is captured by a high-speed camera in a side view, the imbibition is observed with a top view camera, and the temperature distribution at the substrate-coating interface is captured by an infrared camera. Based on the transient temperature field, corresponding heat flux distributions are determined. For the detailed analysis of the interplay between hydrodynamics and heat transfer, the nanofiber coating thickness and substrate temperature have been varied. It has been found that the drop drying time and maximal imbibed area depend non-monotonously on the coating thickness. Changing the initial wall temperature leads to qualitatively different distribution of the heat flux at the substrate surface.

Glass Coating Deposition Temperature on the Inner Surface of Heat-Exchange Tube

Heat Transfer Through Glassfiber Fabrics Coated with Silicone Resin

Influences of Structural Parameters on the Thermal Properties of Coated Glass Fiber Fabrics under Ablation Condition Investigated by Numerical Model

Experimental investigation on convective condensation heat transfer in horizontal 4mm diameter coated tube

Stress State of a Glass Coating In Pipes

Preparation of Aluminide Coatings on the Inner Surface of Tubes by Heat Treatment of Al Coatings Electrodeposited from an Ionic Liquid

Glass Film Formation on GOES Surface during High-Temperature Annealing: The Mechanism with Amorphous Phase Formation

Water drops on nanofiber-coated substrates: Influence of wall temperature and coating thickness on hydrodynamics and wall heat flux distribution

High-temperature Melt-Infiltration Preparation and Erosion Behavior of Γ-Y2si2o7 /Y2o3-Sio2-al2o3 Glass Coating on Porous Si3N4 Ceramics

Investigation of the effects surface alteration via coatings on the condensation heat transfer and wettability

Preliminary Analysis of Heating up Process for Glass Tempering

Investigation on heat transfer coefficient of glass lubricated interface between P92 heat-resistant steel and H13 steel

Heat Transfer at Film Cooling of an Array of Horizontal Tubes with an Enhanced Surface

Performance studies of novel all-glass heat pipe evacuated collector tube integrating numerical simulation and experiment method

Lubrication Behavior of the Glass Lubricated Hot Extrusion Process

Influence of the Shrinkage of the Inner Layer of Steel Tubes on Permissible Thermal Load

Research on the shape of glass pad for hot extrusion of stainless steel tube

The Deposition Behavior Of Fine Glass Particle Of Pcvd

Evaporation Heat Transfer Characteristics On The Outside Of Horizontal Smooth, Herringbone And Enhanced Surface 1eht Tubes

The influence of MCrAlY coating application and its thickness on the heat transfer during water spray cooling

Heat transfer in the falling liquid film on an array of horizontal tubes with MAO coating