Abstract:The National Institute for Occupational Safety and Health (NIOSH) developed a standard for respirator certification under 42 CFR Part 84, using a TSI 8130 automated filter tester with photometers. A recent study showed that photometric detection methods may not be sensitive for measuring engineered nanoparticles. Present NIOSH standards for penetration measurement are mass-based; however, the threshold limit value/permissible exposure limit for an engineered nanoparticle worker exposure is not yet clear. There is lack of standardized filter test development for engineered nanoparticles, and development of a simple nanoparticle filter test is indicated. To better understand the filter performance against engineered nanoparticles and correlations among different tests, initial penetration levels of one fiberglass and two electret filter media were measured using a series of polydisperse and monodisperse aerosol test methods at two different laboratories (University of Minnesota Particle Technology Laboratory and 3M Company). Monodisperse aerosol penetrations were measured by a TSI 8160 using NaCl particles from 20 to 300 nm. Particle penetration curves and overall penetrations were measured by scanning mobility particle sizer (SMPS), condensation particle counter (CPC), nanoparticle surface area monitor (NSAM), and TSI 8130 at two face velocities and three layer thicknesses. Results showed that reproducible, comparable filtration data were achieved between two laboratories, with proper control of test conditions and calibration procedures. For particle penetration curves, the experimental results of monodisperse testing agreed well with polydisperse SMPS measurements. The most penetrating particle sizes (MPPSs) of electret and fiberglass filter media were ~50 and 160 nm, respectively. For overall penetrations, the CPC and NSAM results of polydisperse aerosols were close to the penetration at the corresponding median particle sizes. For each filter type, power-law correlations between the penetrations measured by different instruments show that the NIOSH TSI 8130 test may be used to predict penetrations at the MPPS as well as the CPC and NSAM results with polydisperse aerosols. It is recommended to use dry air (<20% RH) as makeup air in the test system to prevent sodium chloride particle deliquescing and minimizing the challenge particle dielectric constant and to use an adequate neutralizer to fully neutralize the polydisperse challenge aerosol. For a simple nanoparticle penetration test, it is recommended to use a polydisperse aerosol challenge with a geometric mean of ~50 nm with the CPC or the NSAM as detectors.

Radioactive and non-radioactive aerosol permeability through two types of analytical filters

Radioactive aerosol permeability through Russian radiometric analytical (PF) filters

Tests on the Sampling Performance of 3 Kinds of Filters for Α-Radioactive Aerosol Sampling

Features of direct measurements for evaluation of the volume activity of radionuclides in the air of the working area

Performance Evaluation of High Efficiency Particulate Filters for The Removal of Sub-Micrometer Radioactive Aerosols in Nuclear Power Reactors. Simulation Study

Development of a radiochemical test procedure for the separation of aerosol-borne allergens

Evaluation of filter media for particle number, surface area and mass penetrations.

A novel radiotracer method for filter testing

Features of adsorbed radioactive chemical elements and their isotopes distribution in iodine air filters AU-1500 at nuclear power plants

Investigation of the Filtration Efficiency of HEPA and ULPA Filters in Submicron Particle Size Range

RaB's Recoil Loss Rate of Α Spectrometric Measurement for Radon Progeny under Vacuum

Evaluation of radon adsorption efficiency values in xenon with activated carbon fibers

Performance of High Flow Rate Samplers for Respirable Particle Collection

Construction and Investigation of a Filtration Efficiency Test System for High-Efficiency Filter Materials Based on Mass Concentration

Influence by small dispersive coal dust particles of different fractional consistence on characteristics of iodine air filter at nuclear power plant

Comparison of Quartz and Teflon Filters for Simultaneous Collection of Size-Separated Ultrafine Aerosol Particles and Gas-Phase Zero Samples

Comparative study of pretreatment methods for the determination of metals in atmospheric aerosol by electrothermal atomic absorption spectrometry

Development of a needle trap device packed with modified PAF-6-MNPs for sampling and analysis of polycyclic aromatic compounds in air

Investigation of the Influence of Data Collection and Analysis Procedures on Aerosol Filtration Model Development

Distribution of small dispersive coal dust particles and absorbed radioactive chemical elements in conditions of forced acoustic resonance in iodine air filter at nuclear power plant

Comparison of aerosol and bioaerosol collection on air filters