Abstract:In the later stage of gas well production, water–gas ratio increases, liquid carrying capacity decreases, gas field water accumulates in pipes for a long time, and the corrosion environment of pipelines becomes more and more severe. On the basis of carbon dioxide corrosion, microbial corrosion in gas field water accelerates catalytic pitting and finally leads to serious internal corrosion of pipelines. Therefore, accurate prediction of fluid distribution and flow characteristics in pipes is of great significance for engineering applications. In this work, the location and morphology of the corrosion pit were determined by physicochemical analysis. A computational fluid dynamics (CFD) model was established by using VOF and RNG k- ε models to predict fluid distribution characteristics and fluid accumulation locations in pipelines. The results showed that: 1) Corrosion and perforation occurred in the position of pipeline fluid accumulation. 2) The main elements of the corrosion pit on the inner surface of the pipe sample are O, Fe, C, S and Cl. The main corrosive substances in the pipeline corrosion pit are FeCO 3 and Fe 2 O 3 . 3) The low-lying areas and uphill sections are prone to corrosion. A decrease in the fluid velocity in the pipe and a corresponding increase in the gas–liquid ratio will result in a greater accumulation of liquid in the pipe. 4) Magnetic flux leakage (MFL) detection method can be used to detect the characteristics and distribution of pipeline corrosion defects and determine the corrosion area. The research results are of great significance to the safety evaluation of small diameter pipelines for gathering and transporting in oil fields.

An experimental and numerical investigation of CO2 corrosion in a rapid expansion pipe geometry

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

Numerical Predictions of Uniform CO2 Corrosion in Complex Fluid Domains Using Low Reynolds Number Models

Numerical simulation of carbon dioxide corrosion under flow conditions in an elbow

CFD-Based Erosion and Corrosion Modeling of a Pipeline with CO2-Containing Gas–Water Two-Phase Flow

Comparative investigation on high-pressure flow accelerated corrosion at gradual contraction and gradual expansion pipes

Investigation of Supercritical CO2 Corrosion Behavior of X80 Carbon Steel in Pipelines: an in Situ Experimental and DFT Study

A Technique for Dynamic Corrosion Testing in Supercritical CO2

Failure analysis of CO2 corrosion of natural gas pipeline under flowing conditions

Erosion-Corrosion of AISI 302 Stainless Steel Sudden Expansion Pipes in High Salt Wastewater: Effect of Fluid Flow on Different Positions of a Sudden Expansion Pipe

Corrosion Behavior of Oil Tube Steels under Conditions of Multiphase Flow Saturated with Super-Critical Carbon Dioxide

Augmentation of Polymer-FeCO3 Microlayers on Carbon Steel for Enhanced Corrosion Protection in Hydrodynamic CO2 Corrosion Environments

Erosion-corrosion Failure of REAC Pipes under Multiphase Flow

CFD Simulations of Hydrodynamic Characteristics in a Gas–liquid Vertical Upward Slug Flow

Experimental and Numerical Investigation into the Corrosion Performance of X100 Pipeline Steel under a Different Flow Rate in CO2-saturated Produced Water

EXPERIMENTAL STUDY OF CO_2 CORROSION OF 3Cr PIPE LINE STEEL

The Effect of Flowing Velocity and Impact Angle on the Fluid-Accelerated Corrosion of X65 Pipeline Steel in a Wet Gas Environment Containing CO2

Multi-Physics Coupling Analysis on the Time-Dependent Localized Corrosion Behavior of Carbon Steel in CO2-H2O Environment

Effect of Flow on the Corrosion Behavior of Pipeline Steel in Supercritical CO2 Environments with Impurities

Experimental Investigation on Gas–liquid Two-Phase Slug Flow Enhanced Carbon Dioxide Corrosion in Vertical Upward Pipeline

Failure analysis of local effusion corrosion in small diameter gas pipeline: Experiment and numerical