Deformation behavior and damage characteristics of surface buildings induced by undercrossing of shallow large-section loess tunnels
Jianxun Chen,Chaopeng Tian,Yanbin Luo,Yao Li,Weiwei Liu,Hui Chen,Haoyang Zhu
DOI: https://doi.org/10.1016/j.engfailanal.2024.108422
IF: 4
2024-05-16
Engineering Failure Analysis
Abstract:The ground movement during the construction of shallow loess tunnels can easily cause deformation damage to surface buildings. Most the current studies focus on the damage soft soil and rock tunnels to independent buildings, and there are few studies on the case of building groups in loess areas. Using the new Xi'Yan Railway Luochuan Tunnel as a case study, we conducted on-site testing to study building settlement and crack development characteristics. Three-dimensional numerical simulations were carried out to analyze settlement, flexure deformation, and main tensile strain distribution characteristics of the buildings at different buried depths. The study determines the extent of damage resulting from differential settlement and tension cracks. The results show that construction during the upper, middle, and lower bench stages results in significant ground volume loss, leading to a 'wide and steep' settlement pattern with a maximum settlement value of 567 mm. Building cracks exhibit positive and inverted splayed shapes, with lengths ranging from 0.5 to 6.0 m and widths between 0 to 170 mm. As buried depth increases, maximum settlement, flexure deformation, and main tensile strain of buildings also increase. The severe damage range of buildings initially increases and then stabilizes, with the maximum range caused by differential settlement and tensile cracks being 34 m and 29 m from the tunnel axis, respectively. Based on the analysis of building damage characteristics, it was determined that a combination of surface measures and measures within the tunnel should be used to control building damage caused by tunnel construction. These research findings can serve as valuable references for similar projects.
engineering, mechanical,materials science, characterization & testing