Abstract:A large range of iron-carbon alloys were investigated under milling conditions. The alloy systems used included AISI 1020 mild steel, high-carbon low-alloy forged steel, forged martensitic stainless steel, forged austenitic stainless steel and NiHard, 20% chromium, 27% chromium, 30% chromium white cast irons. A range of mineral slurries was also used which included a corrosive copper-nickel sulfide ore, abrasive quartzite, taconite, molybdenite, and abrasive and corrosive quartzite-pyrrhotite combinations. These ranges of alloy systems and minerals provided suitable comparisons with respect to corrosive and/or abrasive conditions of the mineral slurry together with a suitable variation in microstructural constituents of the ball.Marked-ball wear tests were conducted under laboratory conditions in the main, but a small investigation aimed at identifying the importance of impact was also conducted using large industrial tumbling mills. Seven wear mechanisms were identified from examination of ball surfaces, using scanning electron microscopy. It was determined that wear rate was dependent upon a complex interaction of parameters involving microstructure, hardness ratio of the ball to the mineral, mineral slurry chemistry and pH and oxygen potential, ball mix and size. Adiabatic shear bands were also found in balls which were used in the large industrial mill. A galvanic series of the minerals and grinding media materials was determined from electrochemical tests, indicating the tendency of each grinding material to corrosive wear. The effect of media composition and microstructure was also determined using a strain index method developed in this investigation. In all the tests conducted the harder grinding media produced the most efficient grinding.Wet grinding efficiency was found to be dependent on media hardness, while wear under wet grinding was much higher, in general, than that under dry grinding. With respect to mill size it was found that the smaller laboratory mills tended to overemphasise corrosive wear compared with the larger laboratory mills.

Effect of the operating parameter and grinding media on the wear properties of lifter in ball mills

Impact Load Behavior between Different Charge and Lifter in a Laboratory-Scale Mill

Investigation of the Ball Wear in a Planetary Mill by DEM Simulation

Numerical Prediction of Wear in SAG Mills Based on DEM Simulations

Experimental Research on the Effect of Grinding Parameters on Ceramic Machined Surface Roughness

Effect of Grinding Media Grading on Liner Wear and Load Behavior in a Ball Mill by Using Rocky DEM

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Investigation of the Effect of Filling Level on the Wear and Vibration of a SAG Mill by DEM

Effect of Lifter Shapes on the Mill Power in a Ball Mill

Development of a DEM Method for Predicting Wear Distribution on Particle Scale

Effect of Particle Size on Liner Wear in Semi-Autogenous Mill

Influence of particle shape on liner wear in tumbling mills: A DEM study

Multi-level DEM Study on Liner Wear in Tumbling Mills for an Engineering Level Approach

DEM Investigation of Discrete Heat Transfer Behavior of the Grinding Media in Ball Mills

Investigating the Influence of Medium Size and Ratio on Grinding Characteristics

Factors affecting wear in tumbling mills: Influence of composition and microstructure

The influence of wear volume on surface quality in grinding process based on wear prediction model

Wear Characteristics of the Material Specimen and Method of Predicting Wear in Floating Spline Couplings of Aero-Engine

Frictional Study on 30CrNi2MoVA Steel Based on Experiments and Finite Element Simulation: Wear Prediction

Effect of grinding media on the milling efficiency of a ball mill

Finite element simulation and experimental test of the wear behavior for self-lubricating spherical plain bearings