Abstract:China initiative Accelerator Driven System (CiADS) combines a linac, spallation target and a Lead-cooled Fast Reactor (LFR) together, which is designed to transmute nuclear waste and accelerate the progress of China’s energy technology research towards the goal of carbon neutrality. A LFR uses helical wire-wrap spacers as positioning components to enhance crossflow mixing in the reactor core. To study the velocity distribution and crossflow characteristics in wire-wrapped rod bundle channels, a 2 : 1 magnified scale 7-pin bundle fuel assembly model was fabricated using polymathic methacrylate. Particle image velocimetry (PIV) and computational fluid dynamics (CFD) simulations were used to investigate the velocity distribution in the 7-pin bundle flow channels at Reynolds number of 1250~5000 in the x z plane and Reynolds number of 1500 and 2500 in the x y plane. The deviation between CFD simulation results and PIV experimental data was small, and the Reynolds Average Navier-Stokes model could accurately simulate the flow characteristics of the wire-wrapped fuel rod bundle channels. The maximum crossflow velocity caused by helical wires was about 40% of the axial bulk velocity. The normalized crossflow velocity at the subchannel interface varied approximately sinusoidally with the axial height. As the Reynolds number increased, the velocity distribution trend and the loss rate of axial velocity in flow channels remained essentially constant while the peak value of crossflow velocity increased. The contour images of velocities with different axial heights were obtained from the x y plane, and their velocity distribution had a certain periodicity. The axial velocity loss rate in each subchannel caused by wire-wrap spacer resistance was between 7.35% and 38.51%, and the axial velocity loss rates in inner subchannels were usually higher than those in edge subchannels.

CFD investigation for a 7-pin wire-wrapped fuel assembly with different shapes of fuel duct wall

CFD Investigation on Thermal-Hydraulic Behaviors of a Wire-Wrapped Fuel Subassembly for Sodium-Cooled Fast Reactor

NUMERICAL SIMULATION OF THERMO-HYDRAULIC CHARACTERISTICS OF 7-PIN SFR TEST FUEL BUNDLE WITH VARIABLE-PITCH HELICAL WIRE

CFD Simulation of a 61-pin Wire-wrapped Fuel Subassembly for Sodium Cooled Fast Reactor

Generating Hexahedral Mesh for Wire-wrapped Fuel Assembly With RBF Mesh Deformation Method

CFD Investigation on Thermal-Hydraulic Characteristics of a Helical Cruciform Fuel Bundle

Numerical Study on the Thermal Hydraulic Characteristics in a Wire-Wrapped Assembly of LFRs

Single-phase Flow in Helical Cruciform Fuel Assembly with Conjugate Heat Transfer

CFD Simulation of Flow and Heat Transfer Characteristics in a 5×5 Fuel Rod Bundles with Spacer Grids of Advanced PWR

Numerical Simulation and Analysis on Thermal-hydraulic Behavior of Fuel Assembly for Sodium-cooled Fast Reactor

Thermal-hydraulic Comparisons of 19-Pin Rod Bundles with Four Circular and Trapezoid Shaped Wire Wraps

Periodicity and transversal pressure distribution in a Wire‐wrapped 19‐Pin fuel assembly

PIV and CFD Study on Crossflow Characteristics in a 7-Pin Wire-Wrapped Bundle Channel

CFD analysis for full vessel upper plenum in Maanshan Nuclear Power Plant

CFD Analysis of Flow Blockage Phenomena in a LBE-cooled 19-Pin Wire-Wrapped Rod Bundle

Thermal-hydraulic Analysis of a 7-Pin Sodium-Cooled Fast Reactor Wire-Wrapped Fuel Bundle

Numerical investigation on critical heat flux for 5 × 5 fuel assemblies with a wide range of working conditions

Design of thermal hydraulic experiment facility in fuel transfer tube with CFD method

Analysis of Flow Blockage Accidents in Rectangular Fuel Assembly Based on CFD Methodology

Coupled Neutronics and Thermal–Hydraulics Analysis of Annular Fuel Assembly for SCWR

Investigation on Entropy Generation and Flow Characteristics of 7-Pin Sodium Cooled Wrapped-Wire Fuel Bundle