Abstract:The nanofluids characterization is of fundamental importance to predict their applicability in a real heat transfer situation. In addition to the transport properties, the nanofluid stability is an important factor to be studied, due to the long pumping, heating, cooling and resting cycles the fluids are usually subjected to. Carbon nanotubes have great potential to be used in nanofluids, due to their high thermal conductivity and low density. However, for aqueous medium, stability requires the use of stabilization methods. This work carried out the study of the transport properties and stability of nanofluids with multiwalled carbon nanotubes (MWCNT), using three stabilization methods: Triton X-100 (TrX–MWCNT) and Arabic gum (AG–MWCNT) as surfactants and functionalized carbon nanotubes with COOH group (COOH–MWCNT). These three nanofluids were compared to investigate the best configuration for heat transfer processes. The thermal conductivity was studied using the hot wire method; rheology was studied through three curves in rotational rheometer of concentric cylinders; specific heat was studied by the differential scanning calorimetry method; density was measured by the Coriolis Effect method; nanoparticles size and zeta potential were measured by the dynamic light scattering method. The COOH–MWCNT nanofluids present the highest thermal conductivity increase reaching 15% at 60 °C and 12% at 30 °C with 1wt% while the A.G–MWCNT and TrX–MWCNT reach 11% and 7.5%, respectively, at 30 °C. A.G–MWCNT nanofluids showed greater stability after long sonication times, while COOH–MWCNT presents best dispersion at 0.125 and 0.25 wt%, from 40 to 160 min of sonication. The specific heat increases with temperature and decreases with MWCNT concentration; however, it presents a peculiar increase in the concentration of 0.25 wt%, increasing about 0.5% and 4.5% for A.G–MWCNT and COOH–MWCNT, respectively at 60 °C. COOH–MWCNT nanofluids showed a thixotropic behavior for 0.5 and 1.0 wt% and large viscosity increase reaching 3.75 and 5.5 times the base fluid viscosity at 5 °C and 60 °C, respectively, with 1 wt%. The nanofluids A.G–MWCNT and COOH–MWCNT present good stability, as well as an increase in transport properties, optimized at a concentration close to 0.25 wt% and the COOH–MWCNT nanofluids can be stabilized simply by changing the water pH.

Preparation of Long Duration Stable CNT Nanofluid Using SDS

Improved Dispersion Stability of Water-Based Tio2 Nanofluids Through Combined Effects of Nanoparticle Mixing and Dispersant Addition

Experimental study on the thermal conductivity enhancement of water based nanofluids using different types of carbon nanotubes

Thermo-physical properties of water-based single-walled carbon nanotube nanofluid as advanced coolant

Effect of Preparation Temperature, Surfactant, and Nanoparticles Concentration on the Effective Thermophysical Properties of Multi-walled Carbon Nanotubes’ Nanofluids

Dispersion Stability of Tio2-H2o Nanofluids Containing Mixed Nanotubes and Nanosheets

Understanding Interfacial Dynamics: Hydrostatic Pressure-Induced Sono-Dispersion of Carbon Nanotubes

Solidification characteristic enhancement of aqueous nanofluid with different carbon nanotube sizes

Pool Boiling Heat Transfer During Quenching in Carbon Nanotube (Cnt)-Based Aqueous Nanofluids: Effects of Length and Diameter of the CNTs

Effects of ultrasonication time on stability, dynamic viscosity, and pumping power management of MWCNT-water nanofluid: an experimental study

Preparative Ultracentrifuge Method for Characterization of Carbon Nanotube Dispersions

Mild nitric acid treatments to improve multi-walled carbon nanotubes dispersity and solubility in dielectrophoresis mediums

Long‐Term Stable Dispersion of Multiwalled Carbon Nanotubes by Peroxydisulfate upon Ultrasonication Activation

Sonication-assisted Dispersion of Carbon Nanotubes in Aqueous Solutions of the Anionic Surfactant SDBS:The Role of Sonication Energy

Utilizing Fullerenols as Surfactant for Carbon Nanotubes Dispersions Preparation

Experimental Investigation on Stability, Viscosity, and Electrical Conductivity of Water-Based Hybrid Nanofluid of MWCNT-Fe2O3

MWCNT and COOH–MWCNT aqueous nanofluids: thermophysical and rheological characterization

Dispersion of denatured carbon nanotubes by using a dimethylformamide solution

Preparation of binary nanofluid with heat transfer additives by particle surface functionalisation

Dispersion, sedimentation and aggregation of multi-walled carbon nanotubes as affected by single and binary mixed surfactants

Carbon nanotube dispersion for in-vitro applications