Abstract:Abstract Additive manufacturing (AM) is a developing manufacturing technology, which provides excellent attributes compared to other manufacturing techniques. However, one of the critical challenges is the presence of defects that hinder the mechanical properties of the parts, particularly the fatigue life. Experimental understanding of fatigue is a cumbersome process. Therefore, numerical prediction based on specified conditions (such as porosity and applied load) can be an alternative to experimental analysis at the design stage of AM parts. In this study, elastic–plastic finite element analysis (FEA) is performed to obtain the stress distribution around pores, and their resultant effect on fatigue life for L-PBF (laser powder bed fusion) produced AlSi10Mg alloy samples. The stress field is calculated for both single and multiple pore models, where stress concentration is evaluated as a function of the pore’s location and its size. It is found that both pore location and size affect the stress field; however, location effects dominate over pore size. For the same remote applied stress level, the stress concentration around the pore increases with an increase in pore size, and the local maximum stress occurs near the pores that are closest to the surface. The current study also evaluates the relative effect of porosity fraction, average pore size, and location. It is found that the magnitude and sensitivity of stress concentration are hierarchically controlled by porosity location, pore size, and porosity density. A multi-scale finite element (FE) model is proposed based on inherent porosity data measured using Computed Tomography (CT) to predict overall fatigue life. The fatigue cycles are calculated using the rainflow counting algorithm in FE Safe using the stress–strain data obtained from the proposed FEA model. Using the proposed model, it is possible to generate S–N curves for any loading condition for a given porosity condition (porosity density and average pore size). The S–N curve results obtained from the FE model are compared to the experimental observations. The predicted fatigue life shows approximately 5% error with experimental results at high stress loading conditions. However, the proposed model overpredicts the fatigue life at low stress loading by almost 30%.

Finite Element Analysis of the Effect of Porosity on the Plasticity and Damage Behavior of Mg AZ31 and Al 6061 T651 Alloys

Analysing the effect of defects on stress concentration and fatigue life of L-PBF AlSi10Mg alloy using finite element modelling

Effects of porosity on the mechanical properties of additively manufactured components: a critical review

Sensitivity of void mediated failure to geometric design features of porous metals

Damage Evolution and Characterization for Sintered Powder Metals with the Varying Porosity

Characterization on the formation of porosity and tensile properties prediction in die casting Mg alloys

Effect of porous defects on mechanical behavior of functionally graded materials

Superplastic Instability and Damage Evolution of AZ31B Magnesium Alloy Shee

Milling of additively manufactured AlSi10Mg with microstructural porosity defects, finite element modeling and experimental analysis

A critical review on the effects of process-induced porosity on the mechanical properties of alloys fabricated by laser powder bed fusion

A Continuum Damage Model for Multi-Axial Low Cycle Fatigue of Porous Sintered Metals Based on the Critical Plane Concept

Modeling of microporosity evolution and fatigue life of aluminum alloy castings

Effect of internal defects on tensile strength in SLM additively-manufactured aluminum alloys by simulation

Effect of pore design on the mechanical properties of nanoporous high-entropy alloys

Experimental and numerical investigation on plasticity and fracture behaviors of aluminum alloy 6061-T6 extrusions

Influence of shielding gas flow on pore evolution in AlSi10Mg/In718 alloy by laser powder bed fusion

Mechanical behavior, damage mode and mechanism of AlSi10Mg porous structure manufactured by selective laser melting

Simulation on the Effect of Porosity in the Elastic Modulus of SiC Particle Reinforced Al Matrix Composites

Stochastic fracture of additively manufactured porous composites

A continuum damage model for Mg/Al composite sheets rolling: Theoretical development and application

Preliminary Study on Simulation of Microporosity Evolution and Fatigue Life of Aluminum Alloy Casting