Abstract:Lithium-sulfur battery is cost-effective and has a theoretical specific energy density of up to 2600 W·h·kg-1;moreover,the earth is rich in sulfur resources;therefore,it is considered a promising candidate for next-generation high-energy-density batteries.However,a few obstacles still persist in the process of commercialization,including the insulation of charge and discharge products,huge volume changes,flammable electrolytes,polysulfide"Shuttle Effect",and unstable lithium metal anode.Among these challenges,safety is a main concern in the process of commercialization.Batteries using sulfurized polyacrylonitrile(PAN/S)as positive electrode active material have substantial advantages in terms of lifespan and a wider selection of electrolytes.As lithium polysulfide dissolution has not been considered,phosphate-based electrolytes can be used in this system because they also have good nonflammable properties.Phosphate-based flame retardants or nonflammable solvents can capture combustion free radicals and have excellent flame retardant effects as main solvents and flame retardant additives.This study explores the application of high-concentration triethyl phosphate(TEP)and tri(2,2,2-trifluoroethyl)phosphate(TFP)electrolytes in Li-PAN/S batteries to improve battery safety for next-generation high-energy-density secondary batteries.We investigate the effect of TEP and TFP-based electrolytes on the stability of lithium metal negative and sulfur positive electrodes as well as interfacial reactions during battery cycling.Charge-discharge and Li deposition/stripping tests were conducted using a high-concentration electrolyte with a molar ratio of 1∶2 between LiFSI and TEP.The results reveal that the electrolyte can achieve a 99.6％S utilization at 0.1 Cand stable Li deposition/stripping performance.However,the high viscosity and limited ionic conductivity of electrolyte limit its battery performance under high-loading electrode and high-rate conditions.By conducting electrochemical tests on TEP and TFP-based electrolytes with different TTE dilution ratios,we found that the charge-discharge overpotential of TFP-based electrolytes was higher,making it difficult to stably cycle in Li/Cu half cells.Furthermore,TFP molecules formed an unstable interface layer on the Li metal surface,which deteriorates the cell performance.After diluting TEP-based electrolyte with TTE at a volume fraction of 1:2,excellent rate performance was achieved,with stable cycling of over 200 cycles at a rate of lC and ultimately maintaining a discharge specific capacity of 1038.1 mA·h·g-1.These results highlight the potential of high-concentration TEP as a promising candidate for safer and higher-performing Li-S batteries.

Safer Triethyl-Phosphate-Based Electrolyte Enables Nonflammable and High-Temperature Endurance for a Lithium Ion Battery

Stable Non‐flammable Phosphate Electrolyte for Lithium Metal Batteries via Solvation Regulation by the Additive

Non-flammable fluorobenzene-diluted highly concentrated electrolytes enable high-performance Li-metal and Li-ion batteries

Non-flammable electrolyte for large-scale Ni-rich Li-ion batteries: Reducing thermal runaway risks

Design of Fire‐Resistant Liquid Electrolyte Formulation for Safe and Long‐Cycled Lithium‐Ion Batteries

Nonflammable electrolyte with low exothermic design for safer lithium-based batteries

Ameliorating Phosphonic-Based Nonflammable Electrolytes Towards Safe and Stable Lithium Metal Batteries

Flame-Retardant and Polysulfide-Suppressed Ether-Based Electrolytes for High-Temperature Li-S Batteries

Non‐Flammable Electrolyte with Lithium Nitrate as the Only Lithium Salt for Boosting Ultra‐Stable Cycling and Fire‐Safety Lithium Metal Batteries

Enhancing the Intrinsic Safety of Nickel-Rich Lithium-Ion Batteries by an Ethylene Carbonate-Free Electrolyte with Ethoxy(pentafluoro) Cyclotriphosphazene Additive

A Nonflammable Diethyl Ethylphosphonate-Based Electrolyte Improved by Synergistic Effect of Lithium Difluoro(Oxalato)Borate and Fluoroethylene Carbonate

A Non-Flammable Electrolyte for Lithium-Ion Batteries Containing Lithium Difluoro(oxalato)borate, Propylene Carbonate and Tris(2,2,2-Trifluoroethyl)Phosphate

Triple‐Layered Noncombustible PEO‐Based Solid Electrolyte for Highly Safe Lithium‐Metal Batteries

Nonflammable Phosphate Electrolytes for High-Safety Lithium-Sulfur Batteries

Achieving Uniform Li Deposition and Suppressed Electrolyte Flammability in Li‐Metal Batteries via Designing Localized High‐Concentration Electrolytes

Nonflammable Electrolytes for Lithium Ion Batteries Enabled by Ultraconformal Passivation Interphases

High-stable nonflammable electrolyte regulated by coordination-number rule for all-climate and safer lithium-ion batteries

Bidirectional Interphase Modulation of Phosphate Electrolyte Enables Intrinsic Safety and Superior Stability for High-Voltage Lithium-Metal Batteries.

Fire-extinguishing, recyclable liquefied gas electrolytes for temperature-resilient lithium-metal batteries

A Nonflammable Electrolyte Combining Phosphate and Fluorinated Ether for Li4Ti5O12/LiNi0.5Mn1.5O4 Cells

The High-Fluorinated Bi-Molecular Combination Enables High-Energy Lithium Batteries under Challenging Environment