Abstract:Lithium-sulfur battery is cost-effective and has a theoretical specific energy density of up to 2600 W·h·kg-1;moreover,the earth is rich in sulfur resources;therefore,it is considered a promising candidate for next-generation high-energy-density batteries.However,a few obstacles still persist in the process of commercialization,including the insulation of charge and discharge products,huge volume changes,flammable electrolytes,polysulfide"Shuttle Effect",and unstable lithium metal anode.Among these challenges,safety is a main concern in the process of commercialization.Batteries using sulfurized polyacrylonitrile(PAN/S)as positive electrode active material have substantial advantages in terms of lifespan and a wider selection of electrolytes.As lithium polysulfide dissolution has not been considered,phosphate-based electrolytes can be used in this system because they also have good nonflammable properties.Phosphate-based flame retardants or nonflammable solvents can capture combustion free radicals and have excellent flame retardant effects as main solvents and flame retardant additives.This study explores the application of high-concentration triethyl phosphate(TEP)and tri(2,2,2-trifluoroethyl)phosphate(TFP)electrolytes in Li-PAN/S batteries to improve battery safety for next-generation high-energy-density secondary batteries.We investigate the effect of TEP and TFP-based electrolytes on the stability of lithium metal negative and sulfur positive electrodes as well as interfacial reactions during battery cycling.Charge-discharge and Li deposition/stripping tests were conducted using a high-concentration electrolyte with a molar ratio of 1∶2 between LiFSI and TEP.The results reveal that the electrolyte can achieve a 99.6％S utilization at 0.1 Cand stable Li deposition/stripping performance.However,the high viscosity and limited ionic conductivity of electrolyte limit its battery performance under high-loading electrode and high-rate conditions.By conducting electrochemical tests on TEP and TFP-based electrolytes with different TTE dilution ratios,we found that the charge-discharge overpotential of TFP-based electrolytes was higher,making it difficult to stably cycle in Li/Cu half cells.Furthermore,TFP molecules formed an unstable interface layer on the Li metal surface,which deteriorates the cell performance.After diluting TEP-based electrolyte with TTE at a volume fraction of 1:2,excellent rate performance was achieved,with stable cycling of over 200 cycles at a rate of lC and ultimately maintaining a discharge specific capacity of 1038.1 mA·h·g-1.These results highlight the potential of high-concentration TEP as a promising candidate for safer and higher-performing Li-S batteries.

Nonflammable Phosphate Electrolytes for High-Safety Lithium-Sulfur Batteries

A Novel Zwitterionic Ionic Liquid-Based Electrolyte for More Efficient and Safer Lithium-Sulfur Batteries.

Partially Fluorinated Ether As an Electrolyte Additive to Modify Electrode Surface and Suppress Dissolution of Polysulfides in Li-S Batteries

A Nonflammable and Thermotolerant Separator Suppresses Polysulfide Dissolution for Safe and Long‐Cycle Lithium‐Sulfur Batteries

Safer Triethyl-Phosphate-Based Electrolyte Enables Nonflammable and High-Temperature Endurance for a Lithium Ion Battery

Stable Non‐flammable Phosphate Electrolyte for Lithium Metal Batteries via Solvation Regulation by the Additive

Insight into the probability of ethoxy(pentafluoro)cyclotriphosphazene (PFPN) as the functional electrolyte additive in lithium-sulfur batteries

Electrospinning Fiber Membrane‐Derived Gel Polymer Electrolytes with High Mechanical Strength and Low Swelling Effect for High‐Safety Lithium Metal Batteries

Ameliorating Phosphonic-Based Nonflammable Electrolytes Towards Safe and Stable Lithium Metal Batteries

Non-Flammable Polymer Electrolyte with Fast Ion Conductivity for High-Safety Li Batteries

Electrolyte for Solid Lithium-Sulfur Batteries with High Safety and High Specific Energy

Non-flammable liquid polymer-in-salt electrolyte enabling secure and dendrite-free lithium metal battery

Non-flammable fluorobenzene-diluted highly concentrated electrolytes enable high-performance Li-metal and Li-ion batteries

A novel mixed ether-based electrolyte for lithium–sulfur batteries with Li anode protection by dual salts

Triple‐Layered Noncombustible PEO‐Based Solid Electrolyte for Highly Safe Lithium‐Metal Batteries

High-Safety and High-Voltage Lithium Metal Batteries Enabled by a Nonflammable Ether-Based Electrolyte with Phosphazene as a Cosolvent

Enhancing the Cycling Stability for Lithium-Metal Batteries by Localized High-Concentration Electrolytes with 2-Fluoropyridine Additive

Bidirectional Interphase Modulation of Phosphate Electrolyte Enables Intrinsic Safety and Superior Stability for High-Voltage Lithium-Metal Batteries.

Linear ether-based highly concentrated electrolytes for Li-sulfur batteries

A Highly-Safe Lithium-Ion Sulfur Polymer Battery with SnO2 Anode and Acrylate-Based Gel Polymer Electrolyte

Crosslinked Nanofiber‐Reinforced Solid‐State Electrolytes with Polysulfide Fixation Effect Towards High Safety Flexible Lithium–Sulfur Batteries