Abstract:The ammonia synthesis activities of the anti-perovskite nitrides Co3CuN and Ni3CuN have been compared to investigate the possible metal composition-activity relationship. Post-reaction elemental analysis showed that the activity for both nitrides was due to loss of lattice nitrogen rather than a catalytic process. Co3CuN was observed to convert a higher percentage of lattice nitrogen to ammonia than Ni3CuN and was active at a lower temperature. The loss of lattice nitrogen was revealed to be topotactic and Co3Cu and Ni3Cu were formed during the reaction. Therefore, the anti-perovskite nitrides may be of interest as reagents for the formation of ammonia through chemical looping. The regeneration of the nitrides was achieved by ammonolysis of the corresponding metal alloys. However, regeneration using N2 was shown to be challenging. In order to understand the difference in reactivity between the two nitrides, DFT techniques were applied to investigate the thermodynamics of the processes involved in the evolution of lattice nitrogen to the gas phase via conversion to N2 or NH3, revealing key differences in the energetics of bulk conversion of the anti-perovskite to the alloy phase, and in loss of surface N from the stable low-index N-terminated (111) and (100) facets. Computational modelling of the density of states (DOS) at the Fermi level was performed. It was shown that the Ni and Co d states contributed to the density of states and that the Cu d states only contributed to the DOS for Co3CuN. The anti-perovskite Co3MoN has been investigated as comparisons with Co3Mo3N may give an insight into the role structure type plays in the ammonia synthesis activity. The XRD pattern and elemental analysis for the synthesised material revealed that an amorphous phase was present that contained nitrogen. In contrast to Co3CuN and Ni3CuN, the material was shown to have steady state activity at 400 °C with a rate of 92 ± 15 μmol h-1 g-1. Therefore, it appears that metal composition has an influence on the stability and activity of the anti-perovskite nitrides.

Manipulating the Geometric and Electronic Structures of Manganese Nitrides for Ammonia Synthesis

Regulating Intermediate Adsorption and H2O Dissociation on a Diatomic Catalyst to Promote Electrocatalytic Nitrate Reduction to Ammonia

Alkali and Alkaline Earth Hydrides-Driven N2 Activation and Transformation over Mn Nitride Catalyst.

Synthesis and Structural Study of Substituted Ternary Nitrides for Ammonia Production

Highly active manganese nitride-europium nitride catalyst for ammonia synthesis

Design Principle of Molybdenum-Based Metal Nitrides for Lattice Nitrogen-Mediated Ammonia Production

Earth-abundant manganese nitride catalysts for mild-condition ammonia synthesis

Atomic Nb Anchoring on Graphdiyne As a New Potential Electrocatalyst for Nitrogen Fixation: A Computational View

Key Role of Local Chemistry in Lattice Nitrogen‐Participated N2‐to‐NH3 Electrocatalytic Cycle over Nitrides

The active site of M δ+ tailed by B (or N)-doped graphyne for nitrogen reduction reaction through DFT study

Cooperative Nitrogen Activation and Ammonia Synthesis on Densely Monodispersed Mo-N-C Sites.

Transition and Alkali Metal Complex Ternary Amides for Ammonia Synthesis and Decomposition

NH3 Synthesis Via Electrocatalytic N2 Reduction Reaction on the Defective Surfaces of Nb2Mo2C3Tx MXenes: Theoretical and Experimental Studies

Constructing Mo5+ Sites in Molybdenum Oxide by Lattice Stress for Efficient Ammonia Synthesis

Experimental and theoretical investigations on the anti-perovskite nitrides Co3CuN, Ni3CuN and Co3MoN for ammonia synthesis

Unveiling the Activity Tendency of Well-Defined Metal-N4 Sites for Electrocatalytic Nitrate Reduction

Promoting N-H Bond Formation by an Alkali Metal Hydride under Confinement

Ammonium Dicyanamide As a Precursor for the Synthesis of BN, NbN, Mo2N and WN Nanoparticles

Theoretical and Comparative Analysis of Graphdiyne and Confined Flexible Nitrogen-Doped Graphdiyne-Supported Single-Atom Catalysts for Electrochemical Nitrogen Reduction

Tuning transition metal atoms embedded in N6 cavity structure toward efficient electrocatalytic ammonia synthesis

Atomically Dispersed Manganese Lewis Acid Sites Catalyze Electrohydrogenation of Nitrogen to Ammonia