Abstract:Mechanical behaviors of a Ni-based single crystal superalloy have been investigated by tensile testing at various temperatures. Deformation substructures and mechanisms have been systemically revealed from micrometer to atomic scales by using advanced scanning electron and scanning transmission electron microscopes. Results show that deformation mode of the alloy strongly depends on the temperature due to competitive responses of the gamma and gamma' phases under mechanical loading and their original stress statuses. At temperatures from ambient to 750 degrees C, plasticity is governed by dislocation shearing in both phases, where slip modes of gamma are < 110 >{111} and those of gamma' are < 112 >{111}, < 110 >{111} and < 110 > {001}. At moderate temperatures (850 degrees C <= T <= 900 degrees C), plasticity mainly involves microscopically uniform deformation of both phases. The matrix deforms first so that channels parallel to tensile direction are narrowed due to the Poisson's effect, after that deformation of gamma' follows. The active slip modes are < 110 > {111} for gamma, < 112 >{111}, < 110 >{111}, < 110 >{001}, and < 001 >{001} for gamma'. At temperature higher than 1000 degrees C, plastic strain is also derived from deformation of both phases, but deformation of the matrix plays critical roles, due to relatively weak strength of this phase. The operative slip modes are < 110 > {111} for gamma, but mainly < 110 >{001} and < 001 >{001} for gamma'. Our results clearly provide a comprehensive and multiscale (from micrometer to atomic) understanding on the deformation mechanism of Ni-based superalloys, which can be critically beneficial and offer mechanistic guidelines to design new/next generation superalloys. (c) 2021 Elsevier Ltd. All rights reserved.

Deformation-Induced Dissolution of Ni3Al Particles in Nickel: Atomistic Simulation

A Molecular Dynamics Study on Mechanical Performance and Deformation Mechanisms in Nanotwinned NiCo-based Alloys with Nano-Precipitates under High Temperatures

Molecular Dynamics Simulation of Interdiffusion at the Initial Stage of High-Temperature Synthesis at the Dissolution of a Ni Nanoparticle in an Aluminum Matrix

Temperature Effects on Deformation Substructures and Mechanisms of a Ni-based Single Crystal Superalloy

Dislocation formation and twinning from the crack tip in Ni 3 Al: molecular dynamics simulations

Dislocation formation and twinning from the crack tip in Ni_3Al:molecular dynamics simulations

Synergistic effects of temperature and strain rate on tensile properties of simulated Ni-6Cu alloy with Σ3 non-Arrhenius grain boundary

Mechanical Properties of the Al–Zn–Mg–Fe–Ni Alloy of Eutectic Type at Different Strain Rates

Effect of cross section and temperature on the Ni3Al precipitate on the tensile behavior through molecular dynamics simulation

Molecular Dynamics Simulation of Tensile Mechanical Properties of Ni/Ni<sub>3</sub>Al

Micro Defects Evolution of Nickel-Based Single Crystal Superalloys during Shear Deformation: A Molecular Dynamics Study

Molecular dynamics simulation of the γ’ phase deformation behaviour in nickel-based superalloys

Dislocation Formation and Twinning from the Crack Tip in Ni 3 Al:molecular Dynamics Simulations

High Strain Rate Compressive Deformation Behavior of Nickel Microparticles

Molecular Dynamics Study on the Interactions of 1/2[110] Edge Dislocations with Voids and Ni3Al Precipitates in FCC Ni

Tension-compression asymmetry in Ni/Ni 3 Al interfaces: An atomistic investigation

In situ study of non-equilibrium solidification of CoCrFeNi high-entropy alloy and CrFeNi and CoCrNi ternary suballoys

Using Molecular Dynamic Simulation to Understand the Deformation Mechanism in Cu, Ni, and Equimolar Cu-Ni Polycrystalline Alloys

Deformation and fracture simulation of Ni3Al alloy under shock loads

Ab Initio Molecular Dynamics Simulation Of Structures Of Nial3 Alloys In Liquid And Amorphous Phase

A Molecular Dynamics Study of Ag-Ni Nanometric Multilayers: Thermal Behavior and Stability