Engineering a low-cost diatomite with Zn-Mg-Al Layered triple hydroxide (LTH) adsorbents for the effectual removal of Congo red: Studies on batch adsorption, mechanism, high selectivity, and desorption
Kanakaraj Aruchamy,Ganesan Sriram,Yern Chee Ching,Tae Hwan Oh,Gurumurthy Hegde,Kanalli V. Ajeya,Siddharth Joshi,Ho-Young Jung,Mahaveer Kurkuri,K Vishal,A Ve Sowriraajan
DOI: https://doi.org/10.1016/j.colsurfa.2023.130922
2023-01-07
Abstract:In this work, naturally occurring, low-cost diatomite (De) or diatomaceous earth (DE) adsorbent was treated with various molar concentrations (0.05, 0.1, and 0.2 M) of Zn-Mg-Al layered triple hydroxide (LTH) using a co-precipitation approach. The DE-modified samples were named 0.05 LDE, 0.1 LDE, and 0.2 LDE and employed to remove Congo Red (CR) dye from an aqueous solution. The adsorbents were examined using XRD, BET-N 2 adsorption-desorption method, ATR-IR, FESEM-EDX, and XPS, and also analyzed for zeta potentials of adsorbents at pH values between 5 and 11 to observe their surface charges. The removal efficiencies of CR were 96.5, 99.7, and 94.5% for 20 mg of 0.05 LDE, 0.1 LDE, and 0.2 LDE, respectively, at pH 7. A bare DE, however, showed a removal efficiency of only 7.4%. After CR adsorption, the maximum adsorption capacities (q max ) of the adsorbents were examined using the Langmuir isotherm, and the results showed that 0.1 LDE-CR (44.0 mgg -1 ) had a higher q max than 0.05 LDE-CR (35.6 mgg -1 ), 0.2 LDE-CR (27.9 mgg -1 ), and DE-CR (0.9 mgg -1 ). The optimal adsorbent of 0.1 LDE was utilized for the selectivity and salt effects based on the investigation's efficiency in removing contaminants. 0.1 LDE has been studied for reusability of up to five cycles and can remove CR up to three cycles with 77.7 and 79.9% efficiency using NaCl and NaOH, respectively. The adsorbents may therefore be particularly effective at removing CR from water and beneficial in industrial settings where dye is often used.