Abstract:[Objectives]In this paper,a new kind of Fe3O4-layered double hydroxide composite(MNP-LDH)was prepared by hydro-thermal method and it was used as adsorbent to remove Congo red in the aqueous solution.For comparison,the magnetic Fe3O4nano-particles(MNP)and Mg-Al hydrotalcite(LDH)were prepared in the same time. [Methods]The absorbents were characterized by scanning electron microscope(SEM),transmission electron microscope(TEM),fourier transform infraredspectroscopy(FT-IR),BET surface analyzer and X ray diffraction spectroscopy(XRD). The effects of pH,the initial concentration of Congo red and ultrasonic time on the adsorption rate of Congo red using static adsorption method were investigated in this study. The Congo red concentrations were determined using spectrophotometry.The Langmuir isotherm model was used for the isotherm study and the pseudo-second-order kinetic model was used to study the sorption kinetics. The desorption and regeneration of MNP-LDH was also evaluated. [Results] 1)From SEM and TEM,MNP-LDH and MNP were regular spherical structure and these particle sizes were both about 100 nm. The pore size of MNP-LDH was smaller than that of MNP. The peaks at 400-600 cm-1observed in infrared spectrums were related to Fe—O,Al—O and Mg—O,the peak at 1 300 cm-1was related to C—O and the peak at 3 400 cm-1was ascribed to O—H. The X-ray diffraction spectrum results showed that both materials had Fe3O4crystal and the characteristic peak of MNP-LDH was showed. The single point specific surface area of LDH was smaller than that of MNP-LDH.2)The adsorption capacity of Congo red decreased rapidly with the enhancing pH from 2 to 4 for MNP-LDH,MNP and LDH and then remained constant. The adsorption capacity of MNP-LDH was higher than that of MNP and LDH. 3)The adsorption capacity of MNP-LDH and MNP increased with the increasing of the initial concentration of Congo red. After the initial concentration reached 100 mg·L-1,the materials reached adsorption satura-tion. 4)The adsorption capacity of MNP-LDH increased with the increasing of the reaction time. After the reaction time reached 10 min,MNP-LDH reached adsorption equilibrium. 5)The experimental data fited well with the Langmuir adsorption isotherm and the pseudo-second-order kinetic model. 6)The effect of NaOH on desorption of Congo red was studied in this experiment. The spent MNP-LDH could be refreshed by 0.1 mol·L-1NaOH and it could be reused for four times without any decrease of desorption rate. 7)The prepared material was applied for the removal of Congo red and the recovery for the spiked industrial waste water sample was 113%,which indicated that the material in this work could remove Congo red from the water sample effectively. [Conclusions]The maximum adsorption capacity of MNP-LDH can be 265.96 mg·g-1when pH value is 2.5,reaction time is 15 min and the initial concentration of Congo red is 150 mg·L-1. Moreover,MNP-LDH has good reuse property,which displays that it is an excellent adsorption material.

Eco-friendly approach for effective removal for Congo red dye from wastewater using reusable Zn-Al layered double hydroxide anchored on multiwalled carbon nanotubes supported sodium dodecyl sulfonate composites

The preparation and characterization of Fe3O4-layered double hydroxide composite and its application for the removal of Congo red

Fabrication of polystyrene/CuO@calcined layered double hydroxide microspheres with high adsorption capacity for Congo red

Synthesis of tannic acid based composite for efficient Congo red removal: Isotherm, kinetics, and thermodynamic studies

Preparation and Characterization of MWCNTs/LDHs Nanohybrids for Removal of Congo Red from Aqueous Solution

Adsorption of Congo Red from Aqueous Solution Using ZnO-modified SiO2 Nanospheres with Rough Surfaces

Synthesis of ZrO2/MgAl-LDH composites and evaluation of its isotherm, kinetics and thermodynamic properties in the adsorption of congo red dye

Sodium Dodecyl Sulfate Intercalated and Acrylamide Anchored Layered Double Hydroxides: A Multifunctional Adsorbent for Highly Efficient Removal of Congo Red

Computational supported experimental insights in adsorption of Congo Red using ZnO/doped ZnO in aqueous solution

An integrated strategy for ultra-efficient recovery and sustainable reuse of Congo red from wastewater

Enhanced Adsorption of Anionic Toxic Contaminant Congo Red by Activated Carbon with Electropositive Amine Modification.

Preparation of a novel CSM@ZIF-67 composite microsphere to facilitate Congo red adsorption from dyeing wastewater

Adsorptive Removal of Congo Red Using Organically Modified Zinc–Copper–Nickel Ternary Metal Hydroxide: Kinetics, Isotherms and Adsorption Studies

Synthesis of Mg-Doped CuO Nanoparticles for Efficient Removal of Congo Red Dye from Wastewater: Adsorption Study

The effective removal of Congo red dye via chitosan-layered double hydroxide composite and the deep insight into mechanism

Porous Carbon-Based MgAlF5·1.5H2O Composites Derived from Carbon-Coated Clay Presenting Super High Adsorption Capacity for Congo Red

Selective Adsorption of Congo Red and Cu(II) from Complex Wastewater by Core-Shell Structured Magnetic Carbon@zeolitic Imidazolate Frameworks-8 Nanocomposites

Composite adsorbents of aminated chitosan @ZIF-8 MOF for simultaneous efficient removal of Cu(II) and Congo Red: Batch experiments and DFT calculations

Hierarchical CuO–ZnO/SiO2 Fibrous Membranes for Efficient Removal of Congo Red and 4-Nitrophenol from Water

Fabrication of a corn stalk derived cellulose-based bio-adsorbent to remove Congo red from wastewater: Investigation on its ultra-high adsorption performance and mechanism

MOF-derived double-shelled Fe(OH)3@NiCo-LDH hollow cubes and their efficient adsorption for anionic organic pollutant