ANALYSIS OF METHODS OF FORECASTING THE PRODUCTIVITY OF GEOTHERMAL HEAT EXCHANGERS FOR ESTABLISHING HEAT PUMP INSTALLATIONS
Kostyantyn Predun,Vitalii Voinalovich,Jamil Guliyev
DOI: https://doi.org/10.32347/2076-815x.2024.85.494-504
2024-03-29
Urban development and spatial planning
Abstract:At the current stage of Ukraine's development, the problems of effective use of fuel and energy resources and environmental safety are among the most important. Housing and communal services are among the largest consumers of energy in the state and, accordingly, sources of environmental pollution. The introduction of "green construction" standards in European countries has proven to be effective in reducing the negative impact of construction and engineering infrastructure on the natural environment.
A technical solution to the problem of a source of alternative energy due to the use of the heat of the near-surface layers of the earth's crust is proposed. At the depth of placement of probes-heat exchangers, which are structurally part of heat pump installations, the soil temperature is practically unchanged throughout the year and is positive. Non-freezing glycol solutions are used to increase the operational reliability of the installations.
A comprehensive analysis of publications and literature demonstrates the absence of a clear scenario for the necessary steps to determine the main parameters of high-capacity heat pump units (more than 30 kW). State regulatory documents contain requirements only for relatively small systems in terms of performance. However, even for such systems, the specific values of the selected thermal energy are indicated in the form of ranges, the discrepancy of which reaches almost 40% between the minimum and maximum values for a certain type of soil. Thus, the resulting effect of thermal energy production cannot be determined precisely. The proposed calculation methodology does not allow taking into account the mutual influence of heat exchangers among themselves. Also, it is impossible to take into account the influence of groundwater. But taking into account the low annual energy productivity, this approach can be considered acceptable.
For more powerful systems, it is suggested to perform individual calculations, without a clear road map. Accurate calculations of high-capacity heat pump systems can be carried out only with the help of computer modeling using the finite element method. Initial information can be obtained by placing a test geothermal probe or a group of probes on the project site, with which a thermal response test (TRT) is conducted.