Abstract:We present a Kalman filter-based approach for estimating external forces and torques relying on a dynamic model of a serial-chain robotic manipulator where only motor signals (currents, joint angles, and joint speeds) are measurable. The method does not require any additional sensing compared to standard robot control systems. The approach exploits redundancy in 7DOF arms, but also applies to traditional 6DOF manipulators. Automatic filter calibration routines are presented minimizing the number of parameters that must be tuned in order to successfully apply the proposed scheme and to optimize estimation quality. The approach is verified by measurement data gathered from an ABB YuMi, a dual-arm collaborative robot with 7DOF each arm. Furthermore, measurement results are presented employing force and torque estimates in a compliance control scheme, verifying that the estimation quality achieved is improved compared to existing approaches and is sufficient to employ the estimates in force-controlled applications.Note to Practitioners—More and more robotic applications involve contact with at least partially unknown environments. As a consequence, they require control approaches that go beyond the traditional position control. In particular, information about contact forces and torques has to be taken into account. However, integrating additional sensing equipment to obtain the required force/torque information is often technically challenging and expensive. Cartesian contact force and torque estimation allows obtaining force/torque information solely from available sensors. The estimation technique can be regarded as a virtual sensor, and hence this brief deals with a key technology enabling force controlled robotic applications such as assembly, grinding, and deburring without the need for expensive additional sensing.

Unknown Resistive Torque Estimation of a Rotary Drilling System Based on Kalman Filter

A Novel Moment of Inertia Identification Strategy for Permanent Magnet Motor System Based on Integral Chain Differentiator and Kalman Filter

Fault estimation for rotary steerable drilling tool systems with strong vibrations and unknown terms

An Optimal Active-disturbance-rejection Controller for the Rotary Speed of An Anchor-hole Drill Based on Brain Storm Optimization Algorithm

Motor-Current-Based Estimation of Cartesian Contact Forces and Torques for Robotic Manipulators and Its Application to Force Control

Torque Estimation using Kalman Filter and Extended Kalman Filter Algorithms for a sensorless Direct Torque Controlled BLDC Motor drive: A Comparative Study

Robust Load-Torque Estimation for DC Motor without Torque Sensor

State and Force Estimation on a Rotating Helicopter Blade through a Kalman-Based Approach

External Force Estimation of Impedance-Type Driven Mechanism for Surgical Robot with Kalman Filter.

Active Disturbance-Rejection Controller (ADRC)-Based Torque Control for a Pneumatic Rotary Actuator with Positional Interference

Observer-Based H∞ Controller Design for High Frequency Stick-Slip Vibrations Mitigation in Drill-String of Rotary Drilling Systems

A complex model of a drilling rig rotor with adjustable electric drive

Multiple Model Adaptive Estimation of the Aerodynamic Torque for the Control of Variable Speed Wind Turbines

Force Sensations of Delayed Telerobotic System with Kalman Filter

Identification of parameters in the torsional dynamics of a drilling process through Bayesian statistics

Contact Force Detection and Control for Robotic Polishing Based on Joint Torque Sensors

Automated Continuous Force-Torque Sensor Bias Estimation

Adaptively Robust Rotary Speed Control of an Anchor-Hole Driller under Varied Surrounding Rock Environments

Control of a slender rotary system subjected to dry friction and rub

Research of System of Dynamic Torque Based on Virtual Instruments

Vehicle Tire Traction Torque Estimation Using a Dual Extended Kalman Filter