Abstract:We present a Kalman filter-based approach for estimating external forces and torques relying on a dynamic model of a serial-chain robotic manipulator where only motor signals (currents, joint angles, and joint speeds) are measurable. The method does not require any additional sensing compared to standard robot control systems. The approach exploits redundancy in 7DOF arms, but also applies to traditional 6DOF manipulators. Automatic filter calibration routines are presented minimizing the number of parameters that must be tuned in order to successfully apply the proposed scheme and to optimize estimation quality. The approach is verified by measurement data gathered from an ABB YuMi, a dual-arm collaborative robot with 7DOF each arm. Furthermore, measurement results are presented employing force and torque estimates in a compliance control scheme, verifying that the estimation quality achieved is improved compared to existing approaches and is sufficient to employ the estimates in force-controlled applications.Note to Practitioners—More and more robotic applications involve contact with at least partially unknown environments. As a consequence, they require control approaches that go beyond the traditional position control. In particular, information about contact forces and torques has to be taken into account. However, integrating additional sensing equipment to obtain the required force/torque information is often technically challenging and expensive. Cartesian contact force and torque estimation allows obtaining force/torque information solely from available sensors. The estimation technique can be regarded as a virtual sensor, and hence this brief deals with a key technology enabling force controlled robotic applications such as assembly, grinding, and deburring without the need for expensive additional sensing.

Robust Load-Torque Estimation for DC Motor without Torque Sensor

Torque Estimation using Kalman Filter and Extended Kalman Filter Algorithms for a sensorless Direct Torque Controlled BLDC Motor drive: A Comparative Study

Minimum-Variance Load-Side External Torque Estimation Robust Against Modeling and Measurement Errors

Second-Order Sliding-Mode Observer With Online Parameter Identification for Sensorless Induction Motor Drives

Motor-Current-Based Estimation of Cartesian Contact Forces and Torques for Robotic Manipulators and Its Application to Force Control

A Robust Backstepping Sensorless Control for Interior Permanent Magnet Synchronous Motor Using a Super‐Twisting Based Torque Observer

Second-order sliding mode-direct torque control and load torque estimation for sensorless model reference adaptive system–based induction machine

Sensorless Control Method Of Pmsm Based On Extended Kalman Filter

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

A new sliding mode position controller with adaptive load torque estimator for an induction motor

A Novel Sensor-less Direct Torque Control for PMSM Based Extended Kalman Filter

Comparative Study Of An Adaptive Sliding Observer And An Ekf For Speed Sensor-Less Dtc Ipm Synchronous Motor Drives

Sensorless Direct Torque Control for Interior Permanent-Magnet Synchronous Motors Using Square-Wave-Type Stator Flux Injection at Low-Speed Regions

Robustness Improvement of Speed Estimation in Speed-Sensorless Induction Motor Drives

Kriging Assisted On-Line Torque Calculation for Brushless DC Motors Used in Electric Vehicles

Contact Force Estimation for Serial Manipulator Based on Weighted Moving Average with Variable Span and Standard Kalman Filter with Automatic Tuning

A High-Performance Control System Of Pmsm Based On Load Torque Observer

Decoupled Stator Resistance Estimation for Speed-Sensorless Induction Motor Drives Considering Speed and Load Torque Variations

A High-Accuracy Torque Estimation Method of IPMSM Based on Search Coils

High Performance PMSM Sensorless Control with Load Torque Observation