Abstract:Transactions of the Institute of Measurement and Control, Ahead of Print. Accurate dynamic parameters are essential for precise control of model-based manipulators. Due to the direct connection between the joint axis and the motor rotor of the direct drive manipulator, using additional joints would increase the disturbance of the system, leading to substantial trajectory tracking errors, which could potentially harm the manipulator if the tracking error exceeds the limited position of joints, and it also curtails the comprehensive parameter excitation and affects the identification accuracy. Restricting joint movement to a narrow area can prevent this injury, but it also curtails the comprehensive parameter excitation and affects the identification accuracy. To address these challenges, this paper presents a novel method for identifying dynamic parameters of multiple degree-of-freedom (DOF) series direct drive manipulators. Specifically, an open-loop gravity torque compensation strategy with spatial geometric characteristics is introduced to ensure secure operation during manipulator identification processes. Meanwhile, an improved model reference adaptive identification (MRAI) method is presented to estimate the nominal inertia quickly and accurately. Finally, a disturbance observer (DOB) based on minimum model perturbation bound is proposed to compensate for significant variations in model disturbances, enabling stable and precise tracking of planned exciting trajectories. This proves advantageous for fully exciting dynamic parameters and improving identification accuracy. Simulation experiments demonstrate that the tracking error of each joint's exciting trajectory is within 0.07 radians, and the maximum absolute error of identifying dynamic parameters is 0.099169409, which verifies the feasibility and effectiveness of the proposed method.

Identification of parameters in the torsional dynamics of a drilling process through Bayesian statistics

Variational Bayesian State Space Model for Dynamic Process Fault Detection

Hierarchical Bayesian Operational Modal Analysis: Theory and Computations

Dynamic Modeling of a Ball-Screw Drive and Identification of Its Installation Parameters

Simultaneous Identification of Propeller Fluctuating Forces and Unknown Parameters Based on a Bayesian Inversion Approach

Computational modeling of the nonlinear stochastic dynamics of horizontal drillstrings

Closed-Loop Dynamic Parameter Identification of Robot Manipulators Using Modified Fourier Series

Nonparametric Modeling and Vibration Analysis of Uncertain Jeffcott Rotor with Disc Offset

Process damping identification using Bayesian learning and time domain simulation

Parameter estimation for mechanical systems via an explicit representation of uncertainty

Data-Driven Bayesian Inference for Stochastic Model Identification of Nonlinear Aeroelastic Systems

Dynamics Parameter Identification of Articulated Robot

Unknown Resistive Torque Estimation of a Rotary Drilling System Based on Kalman Filter

Bayesian Estimation of Experimental Parameters in Stochastic Inertial Systems: Theory, Simulations, and Experiments with Objects Levitated in Vacuum

Bayesian model identification through harmonic balance method for hysteresis prediction in bolted joints

Model Parameter Identification of a Machining Robot Using Joint Frequency Response Functions

ABC for model selection and parameter estimation of drill-string bit-rock interaction models and stochastic stability

A novel dynamic parameter identification method for the multi-degrees-of-freedom series direct drive manipulator

Identification of Dynamic Parameters of Journal Bearings in an Asymmetric Rotor-Bearing System

A Two-Step Method for Dynamic Parameter Identification of Indy7 Collaborative Robot Manipulator

A Bayesian approach for shaft centre localisation in journal bearings