Bearing capacity of composite shear wall incorporating a concrete-filled steel tube boundary and column-type reinforced wall

Zhao Nannan,Wang Yaohong,Han qing,Su Hao

DOI: https://doi.org/10.1177/1369433220911156

2020-03-04

Advances in Structural Engineering

Abstract:Composite shear walls are widely used in high-rise buildings because of their high bearing capacity. To improve the bearing capacity of ordinary shear walls, restraining elements are usually installed at both boundaries or within the wall body. In this article, two different restraining elements, namely, a rectangular steel tube and a column-type reinforcement (the whole wall body was restrained by segmented stirrups and tied by diagonal bars), were applied to the boundary frame and wall body of the shear wall either jointly or separately. A new type of steel-concrete composite shear wall, referred to as a composite shear wall incorporating a concrete-filled steel tube boundary and column-type reinforced wall, was proposed. In addition, three specimens with different restraining elements, namely, a column-type reinforced shear wall, a concrete-filled steel tube boundary shear wall and an ordinary reinforced concrete shear wall, were presented for comparison. The influences of the two different restraining elements on the seismic performance and bearing capacity of the shear walls were analyzed from four perspectives of failure mode, hysteresis behavior, stiffness and residual deformation, and the equivalent lateral pressures of the two restraining elements were calculated. Based on the plane-section assumption, expressions for the crack, yield, peak and ultimate bearing capacities were derived, and the effects of the two restraining elements on the peak and ultimate bearing capacities were considered. The results show that these two restraining elements significantly improved the bearing capacity of the shear wall specimens, and the concrete-filled steel tube restraining element was more effective than the column-type reinforced restraining element. Finally, the calculated values of the bearing capacity of the four different restraining elements of the shear wall specimens proposed in this article were in good agreement with the experimental values.

construction & building technology,engineering, civil

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to improve the bearing capacity and seismic performance of shear walls. Specifically, the paper explores improving the bearing capacity of ordinary shear walls by applying two different restraining elements - rectangular steel tubes and column - type reinforcement elements - in the boundary frames and walls of shear walls. The main objective of the research is to analyze the influence of these two different restraining elements on the failure mode, hysteretic behavior, stiffness and residual deformation of shear walls, and calculate the equivalent lateral pressure of these two restraining elements. Based on the plane cross - section assumption, expressions for cracks, yielding, peak and ultimate bearing capacity are derived, and the influence of the two restraining elements on the peak and ultimate bearing capacity is considered.

Through experimental testing and theoretical analysis, the paper aims to verify the effectiveness of these two restraining elements and provide scientific basis and technical support for the design of composite shear walls with higher bearing capacity and better seismic performance.