Constructing honeycomb conductive rings in graphene foam/epoxy resin metacomposites for adjustable negative permittivity, low dielectric loss tangent and mechanical enhancement

Jingnan Ni,Ruoyu Zhan,Jun Qiu
DOI: https://doi.org/10.1016/j.orgel.2020.105706
IF: 3.868
2020-07-01
Organic Electronics
Abstract:The reduced graphene foam (RGF)/epoxy resin (EP) elastomer composites with adjustable negative permittivity were prepared sequentially through hydrothermal reaction, high-temperature reduction and impregnating processing. The negative permittivity can be achieved by graphene foam owing to the existence of three-dimensional conductive honeycomb rings, and the rise of graphite oxide (GO) content brought in enhancement for negative permittivity. The fundamental principles of Lorentz-like and Drude-type negative permittivity were discussed. The negative permittivity increased significantly as filling multi-walled carbon nanotubes (MWCNTs) with a mass ratio of 2:1 based on the more electrons can hop between the MWCNTs. Low dielectric loss tangent (tan ) (close to 1.0 over 600 MHz-1 GHz) was investigated in RGF/EP composites as a result of reducing conductance loss, interfacial polarization and dipole polarization loss. Besides, compression strength and compression modulus of the RGF/EP composites also were enhanced with increase of GO content. This work provides an understanding guidance on the mechanism of metamaterials with low dielectric loss and high mechanical property.
What problem does this paper attempt to address?