Abstract:This paper studies a dual-wavelength single-frequency Er-doped fiber laser based on ring cavity, the output wavelengths are 1 570 nm and 1 548 nm. The laser combines Fabry-Perot (FP) filter and Fiber Bragg Grating (IFBG) to achieve wavelength selection and preliminary stabilization. And two unpumped Er-doped fibers act as saturable absorbers to realize linewidth narrowing effect. The Laser Diode (L.D) used has a maximum drive current of 700 mA, which corresponds to a maximum pumping power of 450 mW and 500 mW. When the pump power of LD1 is up to 58 mW and the diver current of LD2 is up to 138 mW, the fiber laser gets dual-wavelength output. The output power of the 1 570 nm and 1 548 nm laser generated at this time are 4.2 mW and 10.1 mW respectively. Then the pump power of LD1 and LD2 are adjusted to 104 mW and 83 mW respectively, and the output laser characteristics were studied under this condition. The output power in 1 570 nm is 10.3 mW, the Optical Signal to Noise Ratio (OSNR) is 58 dB. The output power in 1 548 nm is 4.7 mW, and the OSNR is 55 dB. It shows that the output laser has a relatively high-quality factor and high slope efficiency. Then the stability of the output laser is studied. In order to measure the stability of the output laser of the dual-wavelength single-frequency laser, data collection is started half an hour after the laser is turned on in the experiment. Every 10 min, the spectrum is collected and the output power is recorded. The power fluctuations of the laser output in 1 370 run and 1 548 nor are 0.01 dBm and 0.02 dBm, respectively, and the wavelength drifts of the output laser are both less than 0.01 nm. The result shows that the fiber laser can avoid the mutual interference between the two wavelengths. The output laser has good power stability and wavelength stability. The laser linewidth is the parameter of most concern fora single-frequency fiber laser. In this experiment, the linewidths of the output laser are measured by the delay non zero self heterodyne method based on the Mach-Zehnder interferometer and fitted with the Lorentz curve. And it can be calculated from the 20 dB bandwidth of the Lorentz curve. The linewidths of output laser in 1 570 urn and 1 548 urn measured are about 230.2 Hz and 223.6 Hz. The narrow linewidth indicates that the output laser has good single frequency performance, and it is also an important basis for the wide application of this laser. In this study, the idea of multiplexing Fiber Fabry-Perot (FFP) filter is proposed, and the two sub-cavities do not interfere with each other by introducing circulator at both ends of FFP. It also does riot introduce any expensive polarization devices, and does riot need to use a polarization controller to control the polarization state of the tight in the cavity. So it greatly reduces the difficulty of experimental operation and cost of the experiment. The fiber laser has a simple structure, good stability and the output laser has a narrow linewidth. It provides a technical method for realizing dual-wavelength single frequency laser output, and it can also be used as a seed tight source in high precision measurement field.

Frequency-sweeping single-frequency polarization-maintaining Er-doped fiber laser for FMCW lidar

Multifrequency Erbium-Doped Fiber Laser Operating at Room Temperature

Hybrid Integrated Ultralow-Linewidth and Fast-Chirped Laser for FMCW LiDAR

Stable actively Q-switched single-frequency fiber laser at 1.5 μm based on self-injecting polarization modulation

Single-frequency pulsed fiber laser based on an electro-optic modulator with injection seeding technique

1.5 μm polarization-maintaining dual-wavelength single-frequency distributed Bragg reflection fiber laser with 28 GHz stable frequency difference

Linear cavity erbium-doped fiber laser employing PM-PCF based Sagnac loop comb filter for wavelength tunable laser generation

Single-polarization, switchable dual-wavelength erbium-doped fiber laser with two polarization-maintaining fiber Bragg gratings

1 \mu M Wavelength Swept Fiber Laser Based on Dispersion-Tuning Technique

Single-frequency linear cavity erbium-doped fiber laser for fiber-optic sensing applications

Ultrafast tunable photonic integrated Pockels extended-DBR laser

Fiber Fabry-Perot tunable filter based Fourier domain mode locking swept laser source

Frequency agile photonic integrated external cavity laser

High Energy and High Power Single Frequency 1572 nm Laser With an All-Fiber MOPA

Wavelength-switchable ultra-narrow linewidth fiber laser enabled by a figure-8 compound-ring-cavity filter and a polarization-managed four-channel filter

Linear Wavelength-Scanning Narrow Linewidth Er~(3+)-doped Fiber Laser Based on Tunable F-P Cavity Filter

All-Fiber Ring-Cavity Based Frequency Swept Laser Source for Frequency Domain Oct

Mode-Locked Fiber Laser with up to 19 kHz Wavelength Sweep Rate via External Pump LD Modulation

Hybrid integrated low noise linearly chirped Frequency Modulated Continuous Wave laser source based on self-injection to external cavity

100nm Widely Tunable Er-doped Fiber Laser

1 570 nm and 1 548 nm Dual-wavelength Single-frequency Er-doped Fiber Laser