Abstract:This paper studies a dual-wavelength single-frequency Er-doped fiber laser based on ring cavity, the output wavelengths are 1 570 nm and 1 548 nm. The laser combines Fabry-Perot (FP) filter and Fiber Bragg Grating (IFBG) to achieve wavelength selection and preliminary stabilization. And two unpumped Er-doped fibers act as saturable absorbers to realize linewidth narrowing effect. The Laser Diode (L.D) used has a maximum drive current of 700 mA, which corresponds to a maximum pumping power of 450 mW and 500 mW. When the pump power of LD1 is up to 58 mW and the diver current of LD2 is up to 138 mW, the fiber laser gets dual-wavelength output. The output power of the 1 570 nm and 1 548 nm laser generated at this time are 4.2 mW and 10.1 mW respectively. Then the pump power of LD1 and LD2 are adjusted to 104 mW and 83 mW respectively, and the output laser characteristics were studied under this condition. The output power in 1 570 nm is 10.3 mW, the Optical Signal to Noise Ratio (OSNR) is 58 dB. The output power in 1 548 nm is 4.7 mW, and the OSNR is 55 dB. It shows that the output laser has a relatively high-quality factor and high slope efficiency. Then the stability of the output laser is studied. In order to measure the stability of the output laser of the dual-wavelength single-frequency laser, data collection is started half an hour after the laser is turned on in the experiment. Every 10 min, the spectrum is collected and the output power is recorded. The power fluctuations of the laser output in 1 370 run and 1 548 nor are 0.01 dBm and 0.02 dBm, respectively, and the wavelength drifts of the output laser are both less than 0.01 nm. The result shows that the fiber laser can avoid the mutual interference between the two wavelengths. The output laser has good power stability and wavelength stability. The laser linewidth is the parameter of most concern fora single-frequency fiber laser. In this experiment, the linewidths of the output laser are measured by the delay non zero self heterodyne method based on the Mach-Zehnder interferometer and fitted with the Lorentz curve. And it can be calculated from the 20 dB bandwidth of the Lorentz curve. The linewidths of output laser in 1 570 urn and 1 548 urn measured are about 230.2 Hz and 223.6 Hz. The narrow linewidth indicates that the output laser has good single frequency performance, and it is also an important basis for the wide application of this laser. In this study, the idea of multiplexing Fiber Fabry-Perot (FFP) filter is proposed, and the two sub-cavities do not interfere with each other by introducing circulator at both ends of FFP. It also does riot introduce any expensive polarization devices, and does riot need to use a polarization controller to control the polarization state of the tight in the cavity. So it greatly reduces the difficulty of experimental operation and cost of the experiment. The fiber laser has a simple structure, good stability and the output laser has a narrow linewidth. It provides a technical method for realizing dual-wavelength single frequency laser output, and it can also be used as a seed tight source in high precision measurement field.

Linear Wavelength-Scanning Narrow Linewidth Er~(3+)-doped Fiber Laser Based on Tunable F-P Cavity Filter

100nm Widely Tunable Er-doped Fiber Laser

Linear cavity erbium-doped fiber laser employing PM-PCF based Sagnac loop comb filter for wavelength tunable laser generation

High Signal-to-noise Ratio Linear Cavity Multiwavelength Erbium-Doped Fiber Laser with Two Intracavity Fiber Periodic Filters

820 Hz linewidth short-linear-cavity single-frequency fiber laser at 1.5 μm

A Widely Tunable Single-Longitudinal-mode Ytterbium-Doped Fiber Laser Based on Fiber Lyot Filter

Narrow Line-Width Ytterbium-Doped Fiber Ring Laser Based on Saturated Absorber

Tunable Erbium-Doped Fiber Ring Laser Based on an All-Fiber Filter

400 Mw Narrow Linewidth Single-Frequency Fiber Ring Cavity Laser in 2 Um Waveband

Widely tunable single-frequency Er-doped ZBLAN fiber laser with emission from 3.37 to 3.72 µm

Wavelength-switchable ultra-narrow linewidth fiber laser enabled by a figure-8 compound-ring-cavity filter and a polarization-managed four-channel filter

Narrow linewidth fiber laser using compound-ring cavity filter and self-injection locked mechanism

A Tunable Erbium-Doped Fiber Laser with Power-Equalized Output Using Nonlinear Polarization Rotation

Tunable Narrow Linewidth Erbium-Doped Fiber Ring Laser Based on Saturable Absorber and Self-Injection Feedback

A Single-Longitudinal-Mode S + C Band Wavelength-Tunable Fiber Laser

Tunable narrow-linewidth fiber laser based on an optically controlled tunable filter

Single Longitudinal Mode and Widely Tunable Er:Y2O3 Ceramic Laser at ∼ 2.7 Μm

Gain-Switched Er-Doped Fluoride Fiber Laser at ~3.75 μm

Multiwavelength Er-doped fiber laser using an all-fiber Lyot filter

1 570 nm and 1 548 nm Dual-wavelength Single-frequency Er-doped Fiber Laser

Single Longitudinal Mode Narrow Linewidth Thulium-Doped Fiber Laser Based on a Eye-Shaped Dual-Ring Filter