Abstract:<p>Wavelength-switchable fiber laser systems have many potential applications. Herein, the use of an erbium-doped fiber laser based on parallel fiber Bragg gratings (FBGs) (ASE: amplified spontaneous emission; BRM: broadband reflection mirror; CCD: charged-coupled device; EDFL: erbium-doped fiber laser; FBG: fiber Bragg gratings; IR: infrared; MZI: Mach–Zehnder interferometer; OSA: optical spectrum analyzer; OC: output coupler; PC: polarization controller; SNR: signal-to-noise ratios; 3D: three-dimensional; wavelength division multiplexing (WDM)) is proposed to achieve C + L band triple-wavelength-switchable laser output at approximately 1.5 μm. In the proposed system configuration, three parallel FBGs with different resonant wavelengths were fabricated using an 800 nm femtosecond pulsed laser. The proposed fiber laser incorporates first-order FBGs with the periods of 538, 542, and 547 nm. The femtosecond laser was propagated through polyimide coating and cladding and was focused onto the fiber core by a 63× oil lens, while FBGs were inscribed with the use of a point-by-point method to generate resonant wavelengths at 1555.3, 1569.2, and 1583.1 nm. When the FBGs were used as wavelength selectors, a lasing threshold of 85 mW was obtained, and switchable lasing with stable single- and dual-wavelength outputs was achieved based on the adjustment of a polarization controller. Concerning the switchable single-wavelength lasing, the signal-to-noise ratio was greater than 37.23 dB, and the 3 dB linewidth was less than 0.09 nm. The respective power fluctuation measurements were less than 0.22 and 0.68 dB for the single- and dual-wavelength lasers at 26 °C over a scan time of 30 min.</p>

Single-polarization, switchable dual-wavelength erbium-doped fiber laser with two polarization-maintaining fiber Bragg gratings

Wavelength-switchable erbium-doped fiber laser incorporating fiber Bragg grating array fabricated by infrared femtosecond laser inscription

A 100 Mw-Level Single-Mode Switchable Dual-Wavelength Erbium-Doped Fiber Laser

Tunable and Switchable Six-Wavelength Erbium-Doped Fiber Ring Laser

Wavelength-Switchable Fiber Laser Based on Long-Period Fiber Grating Written on Polarization-Maintaining Photonic Crystal Fiber

Switchable multiwavelength ytterbium-doped double-clad fiber laser based on a multimode fiber grating

1.5 μm polarization-maintaining dual-wavelength single-frequency distributed Bragg reflection fiber laser with 28 GHz stable frequency difference

Four-wavelength-switchable SLM fiber laser with sub-kHz linewidth using superimposed high-birefringence FBG and dual-coupler ring based compound-cavity filter

Switchable Quadruple-Wavelength Erbium-Doped Photonic Crystal Fiber Laser Based on a Polarization-Maintaining Photonic Crystal Fiber Sagnac Loop Filter

Stable Multi-Wavelength Erbium-Doped Fiber Laser by Using Dispersion-Shifted Fiber

A novel-configuration multi-wavelength Brillouin erbium fiber laser and its application in switchable high-frequency microwave generation

Wavelength-Spacing Tunable Multi-Wavelength Erbium-Doped Fiber Laser Incorporating A Semiconductor Optical Amplifier

Switchable Dual-Wavelength Thulium-Doped Fiber Laser Based on Polarization-Maintaining Fiber Bragg Grating and Compound Cavity Filter

Polarization-multiplexed, single-cavity dual-comb fiber laser based on a birefringent crystal and a saturable absorber.

Switchable Dual-Wavelength Ytterbium-Doped Fiber Laser Based on a Few-Mode Fiber Grating

Dual-Frequency Operation in a Short-Cavity Ytterbium-Doped Fiber Laser

Multiwavelength Erbium-Doped Fiber Laser Based on an All-Fiber Polarization Interference Filter

Some Switchable Dual-Wavelength Fibre Lasers Based on Fibre Bragg Grating Feedback

Tunable and switchable dual-wavelength Er-doped fiber ring laser using ASEs

2 µm band four-wavelength-switchable narrow linewidth fiber laser enabled by fs-laser direct-written polarization-dependent parallel fiber Bragg gratings