Abstract:An experimentally-calibrated carbon nanotube compact transistor model has been used here to design two high-frequency (HF) circuits with two different functionalities each: a phase configurable amplifier (PCA) and a frequency configurable amplifier (FCA). The former design involves an in-phase amplifier and an inverting amplifier while the latter design embraces a frequency doubler as well as a distinct inverting amplifier. The specific functionality selection of each of the two HF circuit designs is enabled mainly by the inherent ambipolar feature at a device level. Furthermore, at a circuit level the matching networks are the same regardless the operation mode. In-phase and inverting amplification are enabled in the PCA by switching the gate-to-source voltage (VGS) from -0.3 V to 0.9 V while the drain-to-source voltage (VDS) remains at 3 V. By designing carefully the matching and stability networks, power gains of 4.5 dB and 6.7 dB at 2.4 GHz for the in-phase and inverting operation mode have been achieved, respectively. The FCA, in its frequency doubler operation mode, exhibits 20 dBc of fundamental-harmonic suppression at 2.4 GHz when an input signal at 1.2 GHz is considered. This frequency doubler functionality is enabled at VGS=0.3 V, whereas at VGS=0.9 V amplification of 4.5 dB is obtained while VDS remains at 3 V in both cases. In both configurable circuits the stabilization and matching networks are the same regardless the bias-chosen operation mode. The circuits performance degradation due to metallic tubes in the device channel is studied as well as the impact of non-ideal inductors in each design. PCA and FCA operation modes are further exploited in high-frequency modulators.

High-Frequency Performance Study of CNTFET-Based Amplifiers

Design and Optimization of a Milli-Meter Wave Amplifier Using Nano-Scale CMOS Devices

Compact 50-62 GHz Current-Reused Low-Noise Amplifier with Gate-Drain Transformer Feedback

Carbon Nanotube Based Radio Frequency Transistors For K-Band Amplifiers

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

Monolithic Three‐dimensional Integration of Aligned Carbon Nanotube Transistors for High‐performance Integrated Circuits

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

Multifunctional high-frequency circuit capabilities of ambipolar carbon nanotube FETs

Aligned Carbon Nanotubes/Fibers for Applications in Vacuum Microwave Amplifiers

Device design and optimization of CNTFETs for high-frequency applications

Improving Carbon Nanotube-Based Radiofrequency Field-Effect Transistors by the Device Architecture and Doping Process.

Carbon Nanotube Radiofrequency Transistors with F T/f MAX of 376/318 GHz

Optimization of a Nanoscale Operational Amplifier Based on a Complementary Carbon Nanotube Field-Effect Transistor by Adjusting Physical Parameters

Carbon Nanotube Cathodes As Electron Sources for Microwave Amplifiers

Small-signal parameters extraction and noise analysis of CNTFETs

High-frequency Performance of Scaled Carbon Nanotube Array Field-Effect Transistors

Radiofrequency Transistors Based on Aligned Carbon Nanotube Arrays

Carbon Nanotube Film-Based Radio Frequency Transistors with Maximum Oscillation Frequency above 100 GHz.

Aligned Carbon Nanotubes-Based Radiofrequency Transistors for Amplitude Amplification and Frequency Conversion at Millimeter Wave Band

Device and Circuit-Level Performance of Carbon Nanotube Field-Effect Transistor with Benchmarking Against A Nano-Mosfet