Abstract:A linear failure criterion is widely used in slope stability analyses. However, the strength envelope of almost all geomaterials has the nature of nonlinearity. This paper computes rigorous upper bounds on slope stability factors under the condition of plane strain with a nonlinear yield criterion by employing the upper bound theorem of plasticity. A stability factor (or a limit load) computed using a linear Mohr-Coulomb (MC) failure criterion which circumscribes the actual nonlinear failure criterion is an upper bound value of the actual stability factor (or limit load). In this paper, an improved method using a generalized tangential technique to approximate a nonlinear failure criterion is proposed to estimate the stability factor of a slope on the basis of the upper bound theorem of plasticity. Using the generalized tangential technique, the curve of the nonlinear failure criterion is simplified as a set of straight lines according to the linear MC failure criterion. The straight line is tangential to the curve of the nonlinear failure criterion. The set of straight lines of the linear MC failure criterion is employed to formulate the slope stability problem as a classical optimization problem. The objective function formulated in this way is minimized with respect to the location of sliding body center and the location of tangency point. Two typical slope stability problems (a homogeneous soil slope with two slope angles and a vertical cut slope with a tension crack) are analyzed using the proposed method. For the soil slope with two slope angles, the computed results are compared with published solutions by others. The comparison shows that the proposed method gives reasonable and consistent values of the stability factor of the slope. For the vertical cut slope with a tension crack, a statically admissible stress field is constructed for the slope. The stress field does not violate the nonlinear failure criterion. Lower bound solutions are obtained by satisfying stress equilibrium conditions. The upper bound solutions obtained from the proposed method are equal to the lower bound solutions for the vertical cut slope. The agreement further supports the validation of the proposed approach. The influences of the strength parameters in the nonlinear criterion on the stability of slopes are also studied and discussed in this paper.

Lower Bound Limit Analysis Using Power Cone Programming for Solving Stability Problems in Rock Mechanics for Generalized Hoek–Brown Criterion

Upper Bound Analysis of Tunnel Face Stability in Layered Soils

Probabilistic Analysis of Underground Rock Excavations Using Response Surface Method and SORM

Stability of Retained Soils Behind Underground Walls with an Opening Using Lower Bound Limit Analysis and Second-Order Cone Programming

Computational Upper- and Lower-Bound 3D Limit Analysis Using the Hoek–Brown Yield Criterion

Modified Limiting Equilibrium Method for Stability Analysis of Stratified Rock Slopes

Kinematic Limit Analysis of Rock and Soil Slope Stability

A New Discrete Form of Hoek–Brown Criterion and Its Application to Limit Equilibrium Analysis of Rock Slope Stability

Upper Bound Limit Analysis of Slope Stability Based on Translational and Rotational Failure Mechanism

Lower‐bound Limit Analysis by Using the EFG Method and Non‐linear Programming

Upper Bound Limit Analysis for Stability of Jointed Rock Slopes

Stability of Spherical Cavity in Hoek–Brown Rock Mass

Analysis of Stability Against Upheaval of Excavation by Upper Bound Method Considering the Retaining Wall

A Novel Numerical-Iterative-approach for Strain-Softening Surrounding Rock Incorporating Rockbolts Effectiveness and Hydraulic-Mechanical Coupling Based on Three-Dimensional Hoek-Brown Strength Criterion

Pseudo-dynamic stability of rock slope considering Hoek–Brown strength criterion

Stability analysis of twin horse-shoe shaped tunnels in rock mass

Lower bound shakedown analysis by using the element free Galerkin method and non-linear programming

Evaluation of Interslice Force Function and Discussion on Convergence in Slope Stability Analysis by the Lower Bound Method

Slope Stability Analysis with Nonlinear Failure Criterion

A stability analysis of rock slopes using a nonlinear strength reduction numerical manifold method

Three-dimensional upper-bound analysis of rock slopes subjected to seepage forces based on Hoek-Brown failure criterion