Abstract:A linear failure criterion is widely used in slope stability analyses. However, the strength envelope of almost all geomaterials has the nature of nonlinearity. This paper computes rigorous upper bounds on slope stability factors under the condition of plane strain with a nonlinear yield criterion by employing the upper bound theorem of plasticity. A stability factor (or a limit load) computed using a linear Mohr-Coulomb (MC) failure criterion which circumscribes the actual nonlinear failure criterion is an upper bound value of the actual stability factor (or limit load). In this paper, an improved method using a generalized tangential technique to approximate a nonlinear failure criterion is proposed to estimate the stability factor of a slope on the basis of the upper bound theorem of plasticity. Using the generalized tangential technique, the curve of the nonlinear failure criterion is simplified as a set of straight lines according to the linear MC failure criterion. The straight line is tangential to the curve of the nonlinear failure criterion. The set of straight lines of the linear MC failure criterion is employed to formulate the slope stability problem as a classical optimization problem. The objective function formulated in this way is minimized with respect to the location of sliding body center and the location of tangency point. Two typical slope stability problems (a homogeneous soil slope with two slope angles and a vertical cut slope with a tension crack) are analyzed using the proposed method. For the soil slope with two slope angles, the computed results are compared with published solutions by others. The comparison shows that the proposed method gives reasonable and consistent values of the stability factor of the slope. For the vertical cut slope with a tension crack, a statically admissible stress field is constructed for the slope. The stress field does not violate the nonlinear failure criterion. Lower bound solutions are obtained by satisfying stress equilibrium conditions. The upper bound solutions obtained from the proposed method are equal to the lower bound solutions for the vertical cut slope. The agreement further supports the validation of the proposed approach. The influences of the strength parameters in the nonlinear criterion on the stability of slopes are also studied and discussed in this paper.

Upper Bound Limit Analysis for Stability of Jointed Rock Slopes

Kinematic Limit Analysis of Rock and Soil Slope Stability

Upper Bound Limit Analysis of Slope Stability Based on Translational and Rotational Failure Mechanism

Modified Limiting Equilibrium Method for Stability Analysis of Stratified Rock Slopes

Upper Bound Limit Analysis of Slope Stability by Element Integration Method

Strength Properties of Jointed Rock Masses Based on the Homogenization Method

Element Integration Method for upper bound limit analysis

Influence of joint spacing and rock characteristics on the toppling stability of cut rock slope through a simplified limit equilibrium method

Upper bound limit analysis for 3D slope stability analysis based on rigid block structure

Analysis of Stability Against Upheaval of Excavation by Upper Bound Method Considering the Retaining Wall

An Evaluation Approach for Long Term Stability of Expansive Soil Slope

Lower Bound Limit Analysis Using Power Cone Programming for Solving Stability Problems in Rock Mechanics for Generalized Hoek–Brown Criterion

On stability analysis and evaluation of high rock slope based on jointed rock

A LIMIT EQUILIBRIUM METHOD BASED ON MORGENSTERN-PRICE METHOD FOR 3D SLOPE STABILITY ANALYSIS

Rock slope reliability analysis using Barton-Bandis failure criterion with modified pseudo-dynamic approach

Research on upper bound limit analysis of slope stability in open-pit mine based on least square principle

ANALYSIS ON THE STABILITY OF ROCK SLOPE WITH SURFACE INFILTRATION

Slope Stability Analysis with Nonlinear Failure Criterion

Rock slope stability analysis considering the effect of locked section

Stability Analysis of Rock Slope Based on Random Damage Mechanics

Evaluating Slope Stability with 3D Limit Equilibrium Technique and Its Application to Landfill in China