Abstract:A linear failure criterion is widely used in slope stability analyses. However, the strength envelope of almost all geomaterials has the nature of nonlinearity. This paper computes rigorous upper bounds on slope stability factors under the condition of plane strain with a nonlinear yield criterion by employing the upper bound theorem of plasticity. A stability factor (or a limit load) computed using a linear Mohr-Coulomb (MC) failure criterion which circumscribes the actual nonlinear failure criterion is an upper bound value of the actual stability factor (or limit load). In this paper, an improved method using a generalized tangential technique to approximate a nonlinear failure criterion is proposed to estimate the stability factor of a slope on the basis of the upper bound theorem of plasticity. Using the generalized tangential technique, the curve of the nonlinear failure criterion is simplified as a set of straight lines according to the linear MC failure criterion. The straight line is tangential to the curve of the nonlinear failure criterion. The set of straight lines of the linear MC failure criterion is employed to formulate the slope stability problem as a classical optimization problem. The objective function formulated in this way is minimized with respect to the location of sliding body center and the location of tangency point. Two typical slope stability problems (a homogeneous soil slope with two slope angles and a vertical cut slope with a tension crack) are analyzed using the proposed method. For the soil slope with two slope angles, the computed results are compared with published solutions by others. The comparison shows that the proposed method gives reasonable and consistent values of the stability factor of the slope. For the vertical cut slope with a tension crack, a statically admissible stress field is constructed for the slope. The stress field does not violate the nonlinear failure criterion. Lower bound solutions are obtained by satisfying stress equilibrium conditions. The upper bound solutions obtained from the proposed method are equal to the lower bound solutions for the vertical cut slope. The agreement further supports the validation of the proposed approach. The influences of the strength parameters in the nonlinear criterion on the stability of slopes are also studied and discussed in this paper.

An Evaluation Approach for Long Term Stability of Expansive Soil Slope

Shakedown Analysis of Slopes under Alternate Loads

Effect of Alternate Wetting and Drying on the Long Term Stabiity of Slope

Rankine Theory-Based Approach for Stability Analysis of Slurry Trenches

Shakedown Analysis of a Slope with Cyclic Groundwater Level

Analysis of Stability Against Upheaval of Deep Excavation by Upper Bound Method with a Consideration of Confined Water

Study on Stability of Embankment for Flood Control

Effect of Swelling Deformation on Stability of Expansive Soil Slope

Upper Bound Limit Analysis of Slope Stability Based on Translational and Rotational Failure Mechanism

Evaluating Slope Stability with 3D Limit Equilibrium Technique and Its Application to Landfill in China

Analysis of Stability Against Upheaval for Foundation Pit with Anisotropic Soil Strength

Stability Analysis of Overconsolidated Unsaturated Red Clay Slope Based on Modified UH Model

Stability Analysis of Expansive Soil Slope Considering Seepage Softening and Moistening Expansion Deformation

Kinematic Limit Analysis of Rock and Soil Slope Stability

Reliability analysis of progressive failure of strain softening slope

Stability Analysis of a Slope considering Two Reinforcement Processes

A LIMIT EQUILIBRIUM METHOD BASED ON MORGENSTERN-PRICE METHOD FOR 3D SLOPE STABILITY ANALYSIS

Slope Stability Analysis with Nonlinear Failure Criterion

Stability Analysis of Rainfall-Triggered Toe-Cut Slopes and Effectiveness Evaluation of Pile-Anchor Structures

3D Limit Analysis of the Transient Stability of Slope during Pile Driving in Nonhomogeneous and Anisotropic Soil

Seepage and Stability Analysis of Bank Slopes