Abstract:Screw drill is one of the most widely used power drilling tools in the field of deep sea drilling because of its excellent performance such as low drilling speed, high torque, and strong overload capacity. However, it has the problems of complex internal structure and long processing stroke of screw drill stator. In this paper, the electrochemical machining (ECM) technology is used to solve the problem of internal spiral curved surface special-shaped deep hole machining. Firstly, the initial cathode structure with spirally increasing tooth surface of six machining teeth is designed, and the gas-liquid two-phase flow field model of the gap is established to simulate and analyze it. The simulation results show that the flow field distribution of the electrolyte in the machining gap is not uniform and the bubble concentration is high. Secondly, the initial cathode structure is optimized by adding different numbers of liquid-increasing grooves on the tooth surface of the machined tooth, and the gas-liquid two-phase flow field is simulated. The simulation results show that the cathode structure with four additional baths on each tooth surface results in a better overall flow of electrolyte in the machining gap, a flow rate of more than 3 m/s in the machining area, and a significant reduction in the concentration of electrolyte bubbles, with a reduced rate of 18.7% and a smaller distribution area for the highest bubble concentration, ensure the machining accuracy. Finally, the orthogonal experiment of 4 factors and 4 levels was designed, and the optimized processing parameters were obtained by gray correlation analysis method, that is, inlet pressure of 0.4 MPa, machining voltage of 11 V, duty cycle of 40%, and cathode feed rate of 0.9 mm/min, under which the deviation of the large end diameter of the deep special-shaped hole was 0.15 mm, the surface roughness of the inner wall of the hole was 0.487 μm. The data shows that this combination of processing parameters meets the production requirements of the product. The data shows that this combination of machining parameters meets the production requirements of the product. The COMSOL simulation method significantly shortens the research cycle and saves research costs.

Analysis of flow field for electrochemical machining deep spiral hole with gradually changing groove section

Analysis of gas-liquid two-phase flow field with six working teeth spiral incremental cathode for deep special-shaped hole in ECM

Analysis of flow field for ECM square deep hole with two-section square cone combination cathode

Investigation on pulse-vibration electrochemical machining of parallel micro-grooves

Analysis of electrochemical machining of involute internal spline by foamed metal cathode

Simulation and Experimental Research on Electrochemical Machining of Cross Groove

Electrochemical machining of a rhombus hole with synchronization of pulse current and low-frequency oscillations

Simulation study on cathode structure optimization of aluminum alloy thin-walled internal spiral deep hole electrochemical machining

Multiphysics Research on Electrochemical Machining of Micro Holes with Internal Features

Method for controlling the area of the electrolyte outlets in the flow field simulation and experimental verification of electrochemical machining

Electrochemical milling of deep-narrow slots with a pulsating electrolyte flow field

Flow field design and experimental investigation of electrochemical trepanning of diffuser with a special structure

Performance improvement of high-speed EDM and ECM combined process by using a helical tube electrode with matched internal and external flushing

Design and Analysis of Flow Field in Electrochemical Machining of Micro Grooves on Gear Tooth Surface

Formation and reduction of taper in electrochemical single-pass milling grooves

Simulation Analysis of Multi-Physical Field Coupling and Parameter Optimization of ECM Miniature Bearing Outer Ring Based on the Gas-Liquid Two-Phase Turbulent Flow Model

Study on Improving Electrochemical Machining Performances through Energy Conversion of Electrolyte Fluid

Research on jet electrochemical machining with coaxial megasonic assistance

Impact Analysis of Electrolyte Pressure on Shape Accuracy of Micro Holes in ECM with Hollow Electrodes

A Profile Shaping and Surface Finishing Process of Micro Electrochemical Machining for Microstructures on Microfluidic Chip Molds

Research on Ecm Process of Micro Holes with Internal Features