Preparation and characterization of PVA/PAM/NH4SCN polymer film by ultrasound-assisted solution casting method for application in electric double layer capacitor

Ashwini Swaminathan,Ranjithkumar Ravi,M. Sasikumar,Mahadevaiah Dasaiah,G. Hirankumar,Sakunthala Ayyasamy
DOI: https://doi.org/10.1007/s11581-020-03542-4
IF: 2.961
2020-05-19
Ionics
Abstract:<p class="a-plus-plus">The structural analysis of PVA/PAM blend polymer electrolytes made in the different ratio of 70: 30, 50: 50 and 30: 70 by ultrasound-assisted solution casting technique shows a good miscibility between the polymers. The different weight percentage of ammonium thiocyanate (NH<sub class="a-plus-plus">4</sub>SCN) salt as an ionic dopant was added to the PVA/PAM (50: 50) blend film and tested for the structural changes, electrical and electrochemical properties. The 50 wt% PVA-50 wt% PAM-20 wt% NH<sub class="a-plus-plus">4</sub>SCN (UN20) blend film prepared in the presence of ultrasound exhibits a high conductivity value of 1.66 × 10<sup class="a-plus-plus">−4</sup> S cm<sup class="a-plus-plus">−1</sup>, whereas the above blend membrane prepared in the absence of ultrasound (WN20) exhibits a conductivity value of 3.98 × 10<sup class="a-plus-plus">−5</sup> S cm<sup class="a-plus-plus">−1</sup>. The electric double–layer capacitor (EDLC) fabricated using the activated carbon as the electrode and the film UN20 as the polymer electrolyte exhibited a specific capacitance value of 1230 mF g<sup class="a-plus-plus">−1</sup> as observed by the cyclic voltammetry studies, whereas the EDLC made with the film WN20 exhibited a poor specific capacitance value of 293 mF g<sup class="a-plus-plus">−1</sup>. The charge-discharge studies of the device made using the film UN20 was found to exhibit a first cycle discharge capacitance of 2562 mF g<sup class="a-plus-plus">−1</sup> for a current load of 1 mA in the voltage range of 0–1 V. The reasons for the changes in the properties of the films prepared in presence and in absence of the ultrasound and its effect in performance of EDLC were discussed.</p>
chemistry, physical,physics, condensed matter,electrochemistry
What problem does this paper attempt to address?