Abstract:Emission inventories are used to quantify sources and identify trends in the emissions of air pollutants. They use vehicle-specific emission factors that are typically determined in the laboratory, through remote-sensing, vehicle chasing experiments and, more recently, on-board measurements with Portable Emission Measurement Systems (PEMS). Although PEMS is widely applied to measure gaseous pollutants, their application to Solid Particle Number (SPN) emissions is new. In this paper, we discuss the current status of determining SPN emission factors both on the chassis dynamometer in the laboratory and on the road using PEMS-SPN. First, we determine through dedicated tests in the laboratory the influence of the measurement equipment, ambient temperature, driving style, and cycle characteristics, and the extra mass of the PEMS equipment on the SPN emissions of vehicles. Afterward, we present the SPN emissions under type-approval conditions as well as on the road of two heavy-duty diesel vehicles equipped with Diesel Particulate Filter (DPF; one of them Euro VI), two light-duty diesel vehicles equipped with DPF, one light-duty vehicle equipped with a Port Fuel Injection engine (PFI), and seven Gasoline Direct Injection (GDI) passenger cars (two of them Euro 6). We find that cold-start and strong accelerations tend to substantially increase SPN emissions. The two heavy-duty vehicles showed on-road emissions around 2 × 1013 p/km (Euro V truck) and 6 × 1010 p/km (Euro VI truck), respectively. One of the DPF-equipped light-duty vehicles showed emissions of 8 × 1011 p/km, while the other one had one order of magnitude lower emissions. The PFI car had SPN emissions slightly higher than 1 × 1012 p/km. The on-road emissions of GDI passenger cars spanned approximately from 8 × 1011 p/km to 8 × 1012 p/km. For the cars not equipped with a DPF, the on-road SPN emissions remained within a factor of two of the laboratory results. This factor was on average around 0.8 for the Euro 6 and 1.6 for the Euro 5 GDIs. The DPF equipped vehicles showed a difference of almost one order of magnitude between laboratory and on-road tests due to the different DPF fill state and passive regeneration during the tests. The findings of this study can (i) help improving the inventories on SPN emissions and (ii) assist policy makers in designing effective test procedures for measuring the SPN emissions of vehicles under real-world driving conditions.

Assessment of 10-nm Particle Number (PN) Portable Emissions Measurement Systems (PEMS) for Future Regulations

The Methodologies and Instruments of Vehicle Particulate Emission Measurement for Current and Future Legislative Regulations

Evaluation of Two Particle Number (PN) Counters with Different Test Protocols for the Periodic Technical Inspection (PTI) of Gasoline Vehicles

Vehicle Emission Factors of Solid Nanoparticles in the Laboratory and on the Road Using Portable Emission Measurement Systems (PEMS)

Particle Number and Size Distributions (PNSD) from a Hybrid Electric Vehicle (HEV) over Laboratory and Real Driving Emission Tests

Framework for the assessment of PEMS (Portable Emissions Measurement Systems) uncertainty

Characterizing Particulate Polycyclic Aromatic Hydrocarbon Emissions from Diesel Vehicles Using a Portable Emissions Measurement System

Sub-23 nm Particle Emissions from China-6 GDI Vehicle: Impacts of Drive Cycle and Ambient Temperature

Sub-23nm Particle Emissions from China6 Gasoline Vehicles over Various Driving Cycles

Analysis of Particle Number Emissions in a Retrofitted Heavy-Duty Spark Ignition Engine Powered by LPG

NOx, NH3, N2O and PN real driving emissions from a Euro VI heavy-duty vehicle. Impact of regulatory on-road test conditions on emissions

European Regulatory Framework and Particulate Matter Emissions of Gasoline Light-Duty Vehicles: A Review

Characterizing the particle number emissions of light-duty gasoline vehicles under different engine technologies and driving conditions

A miniature Portable Emissions Measurement System (PEMS) for real-driving monitoring of motorcycles

Comparisons of Laboratory and On-Road Type-Approval Cycles with Idling Emissions. Implications for Periodical Technical Inspection (PTI) Sensors

Using Portable Emission Measurement Systems for Transportation Emissions Studies

Comparison of NOx and PN Emissions Between Euro 6 Petrol and Diesel Passenger Cars under Real-World Driving Conditions.

Nanoparticle Emissions of DI Gasoline Cars with/without GPF

Real Driving Particle Number (PN) Emissions from China-6 Compliant PFI and GDI Hybrid Electrical Vehicles

Technical note: Emission factors, chemical composition, and morphology of particles emitted from Euro 5 diesel and gasoline light-duty vehicles during transient cycles

Using Portable Emission Measurement Systems for Transportation Emissions Studies: Comparison with Laboratory Methods