Abstract:Emission inventories are used to quantify sources and identify trends in the emissions of air pollutants. They use vehicle-specific emission factors that are typically determined in the laboratory, through remote-sensing, vehicle chasing experiments and, more recently, on-board measurements with Portable Emission Measurement Systems (PEMS). Although PEMS is widely applied to measure gaseous pollutants, their application to Solid Particle Number (SPN) emissions is new. In this paper, we discuss the current status of determining SPN emission factors both on the chassis dynamometer in the laboratory and on the road using PEMS-SPN. First, we determine through dedicated tests in the laboratory the influence of the measurement equipment, ambient temperature, driving style, and cycle characteristics, and the extra mass of the PEMS equipment on the SPN emissions of vehicles. Afterward, we present the SPN emissions under type-approval conditions as well as on the road of two heavy-duty diesel vehicles equipped with Diesel Particulate Filter (DPF; one of them Euro VI), two light-duty diesel vehicles equipped with DPF, one light-duty vehicle equipped with a Port Fuel Injection engine (PFI), and seven Gasoline Direct Injection (GDI) passenger cars (two of them Euro 6). We find that cold-start and strong accelerations tend to substantially increase SPN emissions. The two heavy-duty vehicles showed on-road emissions around 2 × 1013 p/km (Euro V truck) and 6 × 1010 p/km (Euro VI truck), respectively. One of the DPF-equipped light-duty vehicles showed emissions of 8 × 1011 p/km, while the other one had one order of magnitude lower emissions. The PFI car had SPN emissions slightly higher than 1 × 1012 p/km. The on-road emissions of GDI passenger cars spanned approximately from 8 × 1011 p/km to 8 × 1012 p/km. For the cars not equipped with a DPF, the on-road SPN emissions remained within a factor of two of the laboratory results. This factor was on average around 0.8 for the Euro 6 and 1.6 for the Euro 5 GDIs. The DPF equipped vehicles showed a difference of almost one order of magnitude between laboratory and on-road tests due to the different DPF fill state and passive regeneration during the tests. The findings of this study can (i) help improving the inventories on SPN emissions and (ii) assist policy makers in designing effective test procedures for measuring the SPN emissions of vehicles under real-world driving conditions.

The Methodologies and Instruments of Vehicle Particulate Emission Measurement for Current and Future Legislative Regulations

Assessment of 10-nm Particle Number (PN) Portable Emissions Measurement Systems (PEMS) for Future Regulations

Very Low Particle Matter Mass Measurements from Light-Duty Vehicles

A New Approach for Very Low Particulate Mass Emissions Measurement

Characterizing Particulate Polycyclic Aromatic Hydrocarbon Emissions from Diesel Vehicles Using a Portable Emissions Measurement System

Measurement of Light-Duty Vehicle Exhaust Emissions with Light Absorption Spectrometers

Research of Emission Evaluation Method for Heavy Duty Vehicle

A Method for Measuring Particle Number Emissions from Vehicles Driving on the Road

European Regulatory Framework and Particulate Matter Emissions of Gasoline Light-Duty Vehicles: A Review

A new method to assess vehicle airborne non-exhaust particles: Principle, application and emission evaluation

Green Traffic-Oriented Heavy-Duty Vehicle Emission Characteristics of China VI Based on Portable Emission Measurement Systems

Investigation of alternative metrics to quantify PM mass emissions from light duty vehicles

Considerations in Using Photometer Instruments for Measuring Total Particulate Matter Mass Concentration in Diesel Engine Exhaust

Determination of Suspended Exhaust PM Mass for Light-Duty Vehicles

Vehicle Emission Factors of Solid Nanoparticles in the Laboratory and on the Road Using Portable Emission Measurement Systems (PEMS)

Research on Particle Emissions of Light-duty Hybrid Electric Vehicles in Real Driving

IMPACTS OF AMBIENT TEMPERATURE AND PRESSURE ON PM2.5 EMISSION PROFILES OF LIGHT-DUTY DIESEL VEHICLES

Using Portable Emission Measurement Systems for Transportation Emissions Studies

Identify the Contribution of Vehicle Non-Exhaust Emissions: a Single Particle Aerosol Mass Spectrometer Test Case at Typical Road Environment

Evaluating the Measurement Uncertainty of On-Road NOx Using a Portable Emission Measurement System (PEMS) Based on Real Testing Data in China

Measurement of particulate polycyclic aromatic hydrocarbon emissions from gasoline light-duty passenger vehicles