Abstract:In recent years, constructing natural aggregates as a base layer for the roads has increased. Natural resources will run out as long as human consumption of them continues. Recycled concrete aggregate (RC) has thus emerged as a substitute material for the building of road base layers. Additionally, RC can be utilized to create interior city highways. The base layer for roads must have sufficient strength to support the working load on the pavement surface without damage deforming. As a result, the focus of this paper is on enhancing the structural performance of sandy soil reinforced with various RC percentages. The three key factors are relative soil density (Dr = 83 and 97%), recycled concrete aggregate reinforcing levels (RC = 0,5,10,15,20,25,30,40,50 and 100%), and reinforcement layer thickness (R d = 0.0B, 0.5B, B, and 2B where B is the footing model width). Numerous laboratory experiments were conducted in order to examine the impact of important parameters on the properties of the mixtures. The plate bearing tests were carried out using a footing model (250 × 250 mm) inside a tank (1500 × 1500x1000 mm) to ascertain the stress–strain response, bearing capacity ratio (BCR), ultimate bearing capacity, and modulus of elasticity of the tested mixtures. It is clear that raising the RC has no effect on the diameters of the grains. It was found that as RC increased, the mixture's bulk density increased but specific gravity decreased. Maximum dry density rose as RC rose, whereas water content fell. It was noted that BCR unquestionably increased as RC increased for all RC levels and all values of settlement ratios. The appropriate reinforcing layer thickness is suggested to be no more than 2B. As the RC concentration in the sand and R d increased, the difference between two pressure-settlement curves of densities 83% and 97% significantly decreased. Furthermore, when RC reaches 50%, two curves are roughly comparable. At RC = 50%, it is advised that the relative density of 83% is sufficient to produce the same behavior as the relative density of 97%. It was found that as RC and R d grew, the tested mixtures' ultimate bearing capacity and elasticity modulus increased as well. A novel proposed formulas are developed to compute bearing capacity ratio, ultimate bearing capacity, and elasticity modulus of the tested mixtures taking into account the influence of RC, reinforcement layer depth, settlement ratio, and the relative density, and its results agree with the experimental results.

Performance of subgrade soil stabilised with by-product recycled mill scale and cementitous materials

Aggregation and Dehydration of Excavated Soft Clay and Use for Subgrade Engineering-Part 2: A Pilot-Scale Study

Stabilization of Soft Soil by a Sustainable Binder Comprises Ground Granulated Blast Slag (GGBS) and Cement Kiln Dust (CKD)

Performance enhancement of road base material using calcium carbide residue and sulfonic acid dilution as a geopolymer stabilizer

Experimental Study on Effect of Recycled Reinforced Concrete Waste on Mechanical Properties and Structural behaviour of the Sandy Soil

Investigation of Alkali-Activated Slag-Based Composite Incorporating Dehydrated Cement Powder and Red Mud

Recycling of reclaimed subbase materials in flexible pavement design

Calcium Carbide and Wood Ash as Environmentally Friendly Soil Stabilisers for Enhanced Subgrade Performance

Sustainable Impact of Coarse Aggregate Crushing Waste (CACW) in Decreasing Carbon Footprint and Enhancing Geotechnical Properties of Silty Sand Soil

Enhancing clayey soil performance with lime and waste rubber tyre powder: Mechanical, microstructural, and statistical analysis

Use of Waste Gypsum, Reclaimed Asphalt Filler, and GGBS as a Full Replacement of Cement in Road Base

Performance of Expansive Soil Stabilized with Bamboo Charcoal, Quarry Dust, and Lime for Use as Road Subgrade Material

Improvement of mechanical strength of low-plasticity clay soil using geopolymer-based materials synthesized from glass powder and copper slag

Assessment of the Optimal Ratio of By-product Slag or Traditional Crushed Aggregate in a Replacement Mixture for Soft Soil Improvement and Optimal Replacement Thickness

Evaluation on the Mechanical Properties of Ground Granulated Blast Slag (GGBS) and Fly Ash Stabilized Soil via Geopolymer Process

Experimental Study on Expansive Subgrade Clay Soils Stabilized With Sugarcane Bagasse Ash and Nonwoven Geotextile

A laboratory investigation and numerical modeling on fiber reinforced lime and alkaline binder stabilized pavement subgrade soil

Utilization of Eco-Friendly Construction and Demolition Waste Materials in Soil Improvement

Investigating the Effects of Recycled Micropowder and Aggregate on the Properties of Cement Stabilization of Crushed Aggregate (CSCA)

Measured effects on engineering properties of clayey subgrade using lime–Homra stabiliser

Cement-Stabilized Waste Sand as Sustainable Construction Materials for Foundations and Highway Roads