High-temperature creep deformation in FeCrAl-oxide dispersion strengthened alloy cladding

S. Ukai,S. Kato,T. Furukawa,S. Ohtsuka

DOI: https://doi.org/10.1016/j.msea.2020.139863

2020-09-01

Abstract:<p>The FeCrAl-oxide dispersion strengthened (ODS) alloy is the promising cladding material for the accident-tolerant fuel (ATF) of the light water reactors (LWR) to suppress the oxidation reaction with hot steam by Al₂O₃ formation. Ring-creep tests for FeCrAl-ODS alloy cladding were carried out at 973 K and 1273 K to evaluate the deformation mechanism at the sever accident. The temperature-compensated strain rate by Fe-diffusion coefficient versus the normalized stress by shear modulus was constructed. The dislocation detachment stress from the dispersoid was derived by considering the dislocation-dispersoid elastic interaction and the dislocation relaxation effect by climb motion. When the applied stress exceeds the dislocation detachment stress, dislocations overcome the dispersoids with the reduced values of the stress exponent, which is attributed to the dislocation climb motion. When the stress is lower than the dislocation detachment stress, large size of cavities exists at the grain boundaries. Grain boundary sliding (GBS) is dominant factor for the low strain rate creep deformation at 1273 K, where dislocation climb also plays a critical role for release of the stress concentration induced by GBS. Based on those findings, new constitutive equations for creep deformation were constructed, which is applicable to low stress, low strain rate and high temperature conditions encountered at the reactor sever accident.</p>