Abstract:The quality of borehole sealing is a key factor affecting the efficiency of gas production. A new water-rich grouting material (RW) with composite coagulant and other additives was prepared in this study to overcome the disadvantages of long setting time and low stone rate of traditional cement materials. When the coagulants A is 4 g and coagulants B is 2 g, the setting time of RW material was reduced by 60.85% and 50.62%, which significantly shortened the setting time of the RW material, respectively. Based on the orthogonal method, 29 groups of comparative experiments were designed to investigate the interaction mechanism between different additives on the performance index of RW, including setting time, water secretion rate, and compressive strength. Quadratic regression equations were fitted using the response surface method. All the correlation coefficients R2 of each response model were greater than 0.97, R2 and R2adj were less than 0.2 through variance analysis, indicating a high correlation between the actual and prediction results. The water–cement ratio had the most significant effect among all factors on setting time, water secretion rate, and compressive strength of the RW material. The scanning electron microscope (SEM) was used to compared the micromorphological characteristics of RW and conventional Portland cement material (PC). The results showed that the hydration products of RW were mostly smack ettringite, calcium silicate hydrate gel, and calcium hydroxide, which interweaved with each other to form a network structure that was denser than the PC material. Furthermore, the interface bonding degree between RW and injected coal was tighter than that of PC, without obvious cracks at the slurry–coal interface. The results indicate that the addition of composite coagulant can significantly accelerate the hydration process of RW material and also enhance the interface strength of injected coal, which is conducive to improving the grouting quality and sealing effect of the extraction borehole.

Basic Properties and Engineering Application of Bentonite-Cement-Water Glass Grouting

Sedimentation-affected Engineering Performances and Microstructures of a Hybrid Portland- Sulfate Aluminate Cement Grout Cast in Long Tubes

Experimental study of the direct shear characteristics of cement grout under constant normal loading and stiffness boundary conditions

Effect of Additives on the Rheological and Mechanical Properties of Microfine-Cement-Based Grout

Role of bentonite in improving the anti-seepage durability of fly ash-based geopolymer cutoff wall backfill under dry–wet cycles

Development and application of novel microfine cement-based grout

Strength and Permeability of Bentonite-Assisted Biocemented Coarse Sand

Improving the Anti-washout Property of Acrylate Grouting Material by Bentonite: Its Characterization, Improving Mechanism, and Practical Application

Utilization of untreated-phosphogypsum as filling and binding material in preparing grouting materials

Experimental Investigation of Synchronous Grouting Material Prepared with Different Mineral Admixtures

Investigation and practical application of a new cementitious anti-washout grouting material

Experimental Study on Performance of Modified Cement-Based Building Materials under High-Water-Pressure Surrounding Rock Environment

Development and characterization of volume-stabilized grouts used for borehole heat exchangers

Development and Field Test of New Environmentally Friendly Water-Rich Sand Grout Material

Performance comparison of geopolymer and clay-cement grouting pastes and goaf effect evaluation of grouting backfilling method

Development of High-Performance Microfine Cementitious Grout with High Amount of Fly Ash, Silica Fume, and Slag

Study on the mechanical properties and microstructure of a rich-watered grouting material

Study on the effect of mineral admixtures on working and mechanical properties of the grouting material

Experimental Study on the Effect of Polycarboxylate Superplasticizer on the Performance of Cement-Based Grouting Materials

Performance evaluation of ultrafine cement as a grout for reservoir impermeability improvement

Study on Performance Optimization of Water-Rich Grouting Materials Based on Response Surface Methodology