Abstract:A series of M(x)CoCeMgAlO mixed oxides with different transition metals (M = Cu, Fe, Mn, and Ni) with an M content x = 3 at. %, and another series of Fe(x)CoCeMgAlO mixed oxides with Fe contents x ranging from 1 to 9 at. % with respect to cations, while keeping constant in both cases 40 at. % Co, 10 at. % Ce and Mg/Al atomic ratio of 3 were prepared via thermal decomposition at 750 °C in air of their corresponding layered double hydroxide (LDH) precursors obtained by coprecipitation. They were tested in a fixed bed reactor for complete methane oxidation with a gas feed of 1 vol.% methane in air to evaluate their catalytic performance. The physico-structural properties of the mixed oxide samples were investigated with several techniques, such as powder X-ray diffraction (XRD), scanning electron microscopy (SEM) coupled with energy dispersive X-ray spectroscopy (EDX), elemental mappings, inductively coupled plasma optical emission spectroscopy (ICP-OES), X-ray photoelectron spectroscopy (XPS), temperature-programmed reduction under hydrogen (H2-TPR) and nitrogen adsorption–desorption at −196 °C. XRD analysis revealed in all the samples the presence of Co3O4 crystallites together with periclase-like and CeO2 phases, with no separate M-based oxide phase. All the cations were distributed homogeneously, as suggested by EDX measurements and elemental mappings of the samples. The metal contents, determined by EDX and ICP-OES, were in accordance with the theoretical values set for the catalysts' preparation. The redox properties studied by H2-TPR, along with the surface composition determined by XPS, provided information to elucidate the catalytic combustion properties of the studied mixed oxide materials. The methane combustion tests showed that all the M-promoted CoCeMgAlO mixed oxides were more active than the M-free counterpart, the highest promoting effect being observed for Fe as the doping transition metal. The Fe(x)CoCeMgAlO mixed oxide sample, with x = 3 at. % Fe displayed the highest catalytic activity for methane combustion with a temperature corresponding to 50% methane conversion, T50, of 489 °C, which is ca. 40 °C lower than that of the unpromoted catalyst. This was attributed to its superior redox properties and lowest activation energy among the studied catalysts, likely due to a Fe–Co–Ce synergistic interaction. In addition, long-term tests of Fe(3)CoCeMgAlO mixed oxide were performed, showing good stability over 60 h on-stream. On the other hand, the addition of water vapors in the feed led to textural and structural changes in the Fe(3)CoCeMgAlO system, affecting its catalytic performance in methane complete oxidation. At the same time, the catalyst showed relatively good recovery of its catalytic activity as soon as the water vapors were removed from the feed.

Double perovskite anti-supported rare earth oxide catalyst CeO2/La2CoFeO6 for efficient ventilation air methane combustion

Catalytic performance of La–Ce–O mixed oxide for combustion of methane

Enhanced activity and stability of La-doped CeO2 monolithic catalysts for lean-oxygen methane combustion

Synthesis of Nanoparticle Ce–Mg–O Mixed Oxide As Efficient Support for Methane Oxidation

Enhanced thermal stability of lean methane combustion by structural interactions of CeO 2 with Pt/3DOM LaFeO 3 catalysts

Homogeneously Co/Ce Co-Doped Amorphous MnOx Microspheres with Abundant Oxygen Vacancy for Catalytic Combustion of Propane

Ultrafine Pd species anchored on porous CeO 2 nanobundles as a highly efficient catalyst for methane oxidation

A novel Fe2O3/Al2O3 porous media catalyst prepared by ultrasonic-assisted impregnation for low-concentration methane catalytic combustion

Design of hybrid La1-Ce CoO3- catalysts for lean methane combustion via creating active Co and Ce species

Synthesis and characterization of the flower-like La Ce1−O1.5+ catalyst for low-temperature oxidative coupling of methane

Transition Metal-Promoted LDH-Derived CoCeMgAlO Mixed Oxides as Active Catalysts for Methane Total Oxidation

Uniformly Dispersed Nano Pd-Ni Oxide Supported on Polyporous CeO2 and Its Application in Methane Conversion of Tail Gas from Dual-Fuel Engine

Pseudo core-shell LaCoO3@MgO perovskite oxides for high performance methane catalytic oxidation

Influence of Pd and Rare Earth Metals Oxides (Ce, La) as Modifying Additives in the Co,Ni-Oxide Catalyst Compositions on the Process of Methane Oxidation

Experimental and theoretical investigation of Ce/Ti-doped LaMnO 3 catalysts effect on catalytic oxidation rarefied CH 4 for natural gas engine

Thermally stable Ir/Ce 0.9 La 0.1 O 2 catalyst for high temperature methane dry reforming reaction

Enhancement of the redox reactions of the La0.8Sr0.2MnO3 catalyst by surface acid etching: A simple synthesis strategy to high-performance catalysts for methane combustion

Tailoring La2Ce2O7 catalysts for low temperature oxidative coupling of methane by optimizing the preparation methods

Highly Effective La-deficient La Ce MnO3 Mixed Oxides for the Complete Oxidation of Methane

Encapsulated Co3O4/(SiAl@Al2O3) thermal storage functional catalysts for catalytic combustion of lean methane

Preparation of Ni-Ce-O Mixed Oxide by Oxalate Gel-Coprecipitation Method for Catalytic Combustion of Methane