Abstract:The broadening use of carbon-fiber reinforced plastics (CFRP) in various industries has raised safety concerns. To control the hazard, infrared thermography inspection techniques, capable of large-area scanning, instantaneous imaging, and completely non-contact detection, has been increasingly adopted to detect flaws inside CFRP structures. And in practical engineering, post-processing algorithms are required to eliminate noise and enhance defect detectability after initial inspection course. However, rapid updates of infrared camera bring high-resolution thermograms yet. Whereas classic algorithms have encountered data explosion problem which led to low efficiency and engineering infeasibility. Therefore, to promote the efficiency of postprocessing algorithms, we propose equal interval sampling (EIS) method to sample raw thermal data. Two CFRP laminates with embedded artificial Teflon inserts of different sizes at different depths are inspected by a laser infrared thermography system. The obtained raw thermal videos made up of 500 frame thermal images with 512 × 640 pixels were converted to 3D thermographic data. We apply EIS to sample the data by setting different intervals. And the sampled data are fed to classic post-processing algorithms, thermal signal reconstruction (TSR) and principal component analysis (PCA), which have prevailed in processing thermographic data. Regarding different intervals of EIS as variables, the processing efficiency, and the defect detection performance of EIS-TSR and EIS-PCA are studied. The results demonstrate that EIS-TSR method fails to promote processing speed and maintain the performance of defect detection at the same time. In contrast, the EIS-PCA method attains a remarkable efficiency and intact defect detectability simultaneously, manifesting its adequacy in engineering practice.

Experimental study on infrared phase-locked thermal imaging inspection of carbon fiber reinforced polymer laminates

Experimental study on defects detection in GFRP laminates using lock-in infrared thermography technology

Ultrasonic Inspection Of Localized Defects In Low-Porosity Cfrp

Detection and identification of delamination defects in CFRP laminates using nonlinear frequency-modulated infrared thermal wave testing technology

Ultrasonic Detection Method of Micro Defects in Thick-Section CFRP

A Nonlinear Method for Characterizing Discrete Defects in Thick Multilayer Composites

Joint Scanning Laser Thermography Defect Detection Method for Carbon Fiber Reinforced Polymer

The fusion of lock-in phase images for the damage investigation in composites materials

Multi-frequency Fused Lock-in Thermography in Detecting Defects at Different Depths

Reconstruction of Impact Damage in CFRP Laminate Based on Infrared Thermography

Characterization and depth detection of internal delamination defects in CFRP based on line laser scanning infrared thermography

3D photothermal reconstruction of subsurface defects in notched multidirectional CFRP laminates due to tensile fatigue loading

Linear frequency modulation infrared thermal imaging detection technology for GFRP/PMI foam sandwich structure defects

Enhanced Defect Detection in Carbon Fiber Reinforced Polymer Composites via Generative Kernel Principal Component Thermography

Study on Equal Interval Sampling Method Promoting Efficiency of Post-Processing Algorithms for Infrared Thermography Inspecting Carbon-Fiber Reinforced Plastics Composites

Defect Detection Method for CFRP Based on Line Laser Thermography

Spatio-Temporal 3-D Residual Networks for Simultaneous Detection and Depth Estimation of CFRP Subsurface Defects in Lock-In Thermography

Nondestructive detection of CFRP subsurface defects using transient lock-in thermography

Automatic Detection of CFRP Subsurface Defects via Thermal Signals in Long Pulse and Lock-In Thermography

Nondestructive Evaluation of Composite Bonding Structure Used in Electrical Insulation Based on Active Infrared Thermography

One-dimensional deep convolutional autoencoder active infrared thermography: Enhanced visualization of internal defects in FRP composites