Abstract:The aim of this study was to develop new materials with adsorbent properties that can be used for the adsorption recovery of Au(III) from aqueous solutions. To achieve this result, it is necessary to obtain inexpensive adsorbent materials in a granular form. Concomitantly, these materials must have a high adsorption capacity and selectivity. Other desired properties of these materials include a higher physical resistance, insolubility in water, and materials that can be regenerated or reused. Among the methods applied for the separation, purification, and preconcentration of platinum-group metal ions, adsorption is recognised as one of the most promising methods because of its simplicity, high efficiency, and wide availability. The studies were carried out using three supports: cellulose (CE), chitosan (Chi), and diatomea earth (Diat). These supports were functionalised by impregnation with extractants, using the ultrasound method. The extractants are environmentally friendly and relatively cheap amino acids, which contain in their structure pendant groups with nitrogen and sulphur heteroatoms (aspartic acid—Asp, l-glutamic acid—Glu, valine—Val, DL-cysteine—Cys, or serine—Ser). After preliminary testing from 75 synthesised materials, CE-Cys was chosen for the further recovery of Au(III) ions from aqueous solutions. To highlight the morphology and the functionalisation of the material, we physicochemically characterised the obtained material. Therefore, the analysis of the specific surface and porosity showed that the CE-Cys material has a specific surface of 4.6 m2/g, with a porosity of about 3 nm. The FT-IR analysis showed the presence, at a wavelength of 3340 cm−1, of the specific NH bond vibration for cysteine. At the same time, pHpZc was determined to be 2.8. The kinetic, thermodynamic, and equilibrium studies showed that the pseudo-second-order kinetic model best describes the adsorption process of Au(III) ions on the CE-Cys material. A maximum adsorption capacity of 12.18 mg per gram of the adsorbent material was achieved. It was established that the CE-Cys material can be reused five times with a good recovery degree.

Functionalisation of Mg/Al hydrotalcite and calcined Mg/Al hydrotalcite with gallic acid for reductive adsorption of tetrachloroaurate(III) ion in aqueous solution

Effectively adsorb Au(S2O3)23− using aminoguanidine as trapping group from thiosulfate solutions

Effective utilization of calcined MgAl-layered double hydroxides for adsorption of gold (I) thiosulfate complexes

Removal of Transition Metal Ions from Aqueous Solutions by Adsorption Using a Novel Hybrid Material Silica Gel Chemically Modified by Triethylenetetraminomethylenephosphonic Acid.

Effective Adsorption Ag(I) Onto Triethylenetetramine-Modified Chitosan Beads: Adsorption Equilibrium, Kinetic, and Thermodynamic Studies

Au(III) Adsorption and Reduction to Gold Particles on Cost-Effective Tannin Acid Immobilized Dialdehyde Corn Starch

Aliquat-336 impregnated chitosan microspheres for Au(I) extraction from thiosulfate solution: Preparation, adsorption mechanism, and application

Adsorption of Nitrate and Nitrite from Aqueous Solution Onto Calcined (mg–al) Hydrotalcite of Different Mg/Al Ratio

Adsorption and reduction behavior and mechanism of Au(III) on reductive cellulose-based aerogel

[Selective Adsorption of Au(Ⅲ) by Activated Carbon Supported Polythioamides and Adsorption Mechanism].

Efficient environmental recovery of Au(I) from thiosulfate solution on triphenylphosphine-oxide-modified vermiculite

Removal of Hg(II) with MgAl-layered double hydroxide functionalized by schiff base ligands: Application and condition optimization

Chitosan-thioglycolic acid composite cross-linked with glutaraldehyde for selective recovery of Au(III) ions from e-waste leachate via reduction-coupled adsorption and incineration

Selective recovery of gold ions in aqueous solutions by a novel trithiocyanuric-Zr based MOFs adsorbent

Synthesis of azole-functionalized microspheres and their adsorption properties for gold(I) thiosulfate complex

Analysis of Highly Efficient Adsorption of Au(S 2 O 3 ) 2 3– by Calcined Cu/Fe Layered Double Hydroxides

Synthesis of Some Eco-Friendly Materials for Gold Recovery

Dual thiols-decorated metal–organic framework for efficient separation and recovery of gold

Modification of Activated Carbon by Chemical Vapour Deposition Through Thermal Decomposition of Thiourea for Enhanced Adsorption of Gold Thiosulfate Complex

Adsorption of perchlorate from aqueous solution by the calcination product of Mg/(Al-Fe) hydrotalcite-like compounds

Gold (III) adsorption from dilute waste solutions onto Amberlite XAD7 resin modified with L-glutamic acid