Abstract:To address the challenges of incorrect fault identification and location due to the influence of EMUs, this paper proposes a protection scheme based on the synchronous information from the multiple terminals of HSR, which can identify and locate ground faults in critical conditions. With the rapid development of high‐speed railway, the auto‐transformer traction network (ATN) is also expanding. However, due to the improved performance of electric multiple units (EMUs) and the non‐linear relationship between impedance and ground fault distance, distance protection has limited coverage and cannot accurately locate the fault distance by measuring impedance. This paper presents a model of the ATN considering the presence of EMUs, which effectively demonstrates the characteristics of current distribution under the ground faults. Furthermore, a ground fault identification method based on multi‐terminal currents is proposed to enhance the accuracy of fault identification and differentiate faults and EMUs. The mapping relationship between current distribution and fault location is derived, and an accurate fault location method is proposed. Compared to existing methods, this method is not affected by EMUs and AT parameters. The fault identification and location scheme for ATN employs multi‐terminal synchronous information. Finally, through simulation and experimental setups, case studies have been conducted to verify the accuracy and robustness of the proposed method in various fault scenarios. Certainly, this research has significant application prospects in fault analysis and detection for HSR.

Research on Fault Location for Direct Traction Network

Fault Location Research of DC Railway Traction System Based on Time-domain Differential

Research of Fault Location Method for Metro Traction Power Supply System

Power Flow Algorithm for Traction Power Supply System of Electric Railway Based on Locomotive and Network Coupling

A Unified Fault-Location Method of Autotransformer Traction Network for High-Speed Railway

Study on Short-Circuit Impedance Characteristics in DN Traction Electric Lines

Evaluation of Rail Potential and Stray Current with Dynamic Traction Networks in Multitrain Subway Systems

New Fault Location Method for HV T-connection. Transmission Lines

A Two-Terminal Fault Location Algorithm Using Asynchronous Phasors Based on Distributed Parameter Model

Power Network Fault Location with Exact Distributed Parameter Line Model and Sparse Estimation

Fault Location Algorithm for HV Transmission Lines Immune to Saturation of Current Transformers

Fault Location Method in Power Network by Applying Accurate Information of Arrival Time Differences of Modal Traveling Waves

Fault Model and Travelling Wave Matching Based Single Terminal Fault Location Algorithm for T-Connection Transmission Line: A Yunnan Power Grid Study

Ground fault identification and location of autotransformer traction network for high‐speed railway based on multi‐terminals synchronous measure information

Fault Detection and Location of 35 kV Single-Ended Radial Distribution Network Based on Traveling Wave Detection Method

Research on a New Single-End Fault Location Method for Single-Phase Grounding Faults of Transmission Lines Through Transition Resistance

A Novel Single-Ended Fault Location Method for Locating Double-Phase to Earth Faults

A novel traveling wave fault location method for transmission network based on time linear dependence

A novel noniterative single-ended fault location method with distributed parameter model for AC transmission lines

Fault Analysis and Protection in Flexible DC Traction Power Supply System

Novel travelling wave fault location approach for overhead transmission lines