Hot Deformation Mechanism of a Rapidly-Solidified Al–Zn–Mg–Cu–Zr Alloy
Zhiping Wang,Keneng Li,Tai Luo,Peikang Xia,Jiwei Geng,Yugang Li,Dong Chen,Xianfeng Li,Gang Sha,Haowei Wang
DOI: https://doi.org/10.1016/j.jmrt.2024.06.216
IF: 6.267
2024-01-01
Journal of Materials Research and Technology
Abstract:This study systematically investigates the flow behavior of 7050 aluminum (Al) alloy produced via spray forming and subjected to a proposed pretreatment through thermal compression tests. The experimental findings reveal that the peak stress increased with decreasing deformation temperature or increasing strain rates. The parameters in the Arrhenius constitutive model were determined and verified by experimental results for spray formed (SFed) 7050 Al alloy. Hot deformation activation energy of the SFed 7050 Al alloy (147.38 kJ/mol) is notably lower than that of cast Al–Zn–Mg–Cu–Zr alloys, which is attributed to factors such as fine grains, low segregation, pores, and dispersed Al3Zr induced by pretreatment. Furthermore, processing maps have been constructed at various strains, revealing optimal stable deformation conditions at 300–450 °C/0.001–0.15s−1 and 425–450 °C/0.2–1s−1. Microstructural analysis of deformed samples highlights the critical role of dynamic recrystallization in influencing the stable and unstable areas of the alloy, which may be activated by high temperature and slow strain rate. The hot deformation mechanism of the SFed Al alloy is governed by interactions among η-Mg(Zn,Al,Cu)2 precipitates, dispersed Al3Zr particles, dislocation structures, and (sub-)grain boundaries.