Abstract:The paper presents a numerical study of a medium size model of industrial gas turbine combustor. The research was conducted using the RANS (Reynolds Averaged Navier–Stokes) approach with k–∊ model and LES (Large Eddy Simulation) with WALE (Wall Adapting Local Eddy viscosity) subgrid model. The simulations were performed in cold and reacting flow conditions. In the latter case, the combustion process was modelled using a steady flamelet model with chemical mechanisms of Smooke with 16 species and 25 elementary reactions, and the GRI-2.11 with 49 species and 277 elementary reactions including NO chemistry. In the first part of the paper, the numerical results were validated against experimental data including velocity field, temperature and species concentrations. The velocity components predicted for the cold flow agree very well with measurements. In the case of the simulations of the reacting flow, some discrepancies were observed in both the temperature field and species concentrations. However, the main flame characteristics were captured correctly. It turned out that the chemical kinetics had a larger impact on the results than the turbulence model. In the second part of the paper, we modified the fuel and air injection method and analysed how the changes introduced affect the flame dynamics. It was shown that: (i) depending on the distribution of air, the velocity, temperature and species composition in the upper part of the combustion chamber can be significantly altered; (ii) more substantial changes can be achieved by shifting the fuel injection points; their location outside the main recirculation zone leads to a dangerous situation resulting in overheating of the walls; (iii) it turns out that substantial differences in the flame characteristics in the upper part of the combustion chamber vanish approaching the outlet plane and the resulting mixture compositions are very similar.

Numerical study of the parameters of a gas turbine combustion chamber with steam injection operating on distillate fuel

Control of Liquid Hydrocarbon Combustion Parameters in Burners with Superheated Steam Supply

Numerical simulations of combustion process in a gas turbine with a single and multi-point fuel injection system

Optimizing the Injection of Two-Phase Gasification Products of Power Condensed Compositions into a Model Combustion Chamber with Small Extention

Large Eddy Simulations of Turbulent Combustion of Kerosene-Air in a Dual Swirl Gas Turbine Model Combustor at High Pressures

Investigation of the Efficiency of a Dual-Fuel Gas Turbine Combustion Chamber with a Plasma‒Chemical Element

Numerical simulation of combustion in the chamberof a model low-thrust rocket engine operating on the gaseous oxygen–methane components

Numerical Investigation of Work Cycle Characteristics in the Combustion Chamber of a Lox/Methane Liquid-Propellant Rocket Engine Featuring Reductant Power Gas Combustion

The integrated design of the combustion chamber for a gas-turbine engine using cad/cae systems

Design and development of combustion chambers for gas turbine engines based on calculations of various levels of complexity

Design and Numerical Analysis of an Annular Combustion Chamber

Simulation of heat transfer in combustion chamber waterwall tubes of supercritical steam boilers

Numerical Study on Steam Injection in a Turbocompound Diesel Engine for Waste Heat Recovery

CFD Simulation of Combustion in Gas Turbine Engine

Numerical Investigation of Pre-Chamber Jet Combustion in a Light-Duty Gasoline Engine

Experimental and numerical study on a cavity-swirler-based combustion strategy for advanced gas turbine engine

Investigations of a Gas Turbine Low-Emission Combustor Operating on the Synthesis Gas

Comparative Study on Different Water/steam Injection Layouts for Fuel Reduction in a Turbocompound Diesel Engine

Numerical Investigation of Combustion and Emission With Different Diesel Surrogate Fuel by Hybrid Breakup Model

Numerical investigations on pilot ignited high pressure direct injection natural gas engines: A review