The integrated design of the combustion chamber for a gas-turbine engine using cad/cae systems

Yury I. Tsibisov,M. Orlov,I. Zubrilin,S. Matveev

Abstract:2 JSC "Kuznetsov" plc., Samara, Russia Abstract. At the moment the combustion chamber (CC) is the major unit of a gas turbine engine (GTE), the improvement of which in the long term will determine the improvement of its environmental, resource and others characteristics. The combustion chambers have been designed using conventional methods for quite a long time, where the CC basic geometrical dimensions, the air distribution law and the integral parameter distribution in the basic sections have been determined by calculations. As the design of both the GTE and its combustion chambers became more complicated, there appeared a need to assess at the design stage not only the integral parameters distribution, but also their local values. It provides, for example, a longer fault-free performance of the flame can wall or the turbine engine, and, consequently, a longer engine lifetime in general. In this paper, the approaches to the CC integrated design of the aircraft GTE are expounded in the form of the implemented solution of the designer's objectives. These approaches will ensure the implementation of the main requirements to them. It has been shown how to achieve the desired characteristics of the combustion chamber by improving the performance of its main elements, such as a diffuser, and in case of a multi- injector circuit also by optimizing the distribution of fuel between the injector circuits. The outlined approaches allow solving practical objectives to reduce emissions of air pollutants by a projected combustion chamber and to improve the engine service life rate.

Engineering