Abstract:Lean-burn natural-gas spark-ignition combustion inside a diesel geometry is characterized by two distinct and successive events: a rapid burning process inside the piston bowl, followed by a much slower burn inside the squish region. This paper used experimental data (including images of flame natural luminosity) to investigate the magnitude and phasing of these two combustion stages. The results showed a substantial impact on the parameters generally used to investigate the combustion phenomena in spark-ignition engines (e.g., the 10-to-90-percent energy release). A better solution to identify the start and end of the rapid- and the slow-burning stages in such an engine is to use the inflection points in the apparent rate of heat release. Moreover, as the higher turbulence in a diesel-like environment accelerates flame inception, the 5% or 10% energy release used traditionally to define the flame inception period should not be used for these engines because the enflamed zone already reached an appreciable size at the two corresponding crank angle degrees. Further, the 2nd inflection point in the apparent rate of heat release (i.e., the point where the slow-burning stage started to dominate the heat release) was much advanced compared to 90% energy release generally used to define the end of the rapid-burning stage in conventional stoichiometric spark-ignition engines. Furthermore, as the slow-burning stage was characterized by a lower flame propagation speed, a lower fuel fraction burning during this stage would increase the engine combustion efficiency. Furthermore, a more advanced phasing of the late-burning stage relative to the fast-burn stage would result in a more optimal combustion environment (i.e., higher in-cylinder pressure and temperature), which would further improve the engine efficiency and probably reduce carbon monoxide and unburned hydrocarbon emissions. As a result, this study suggests that the combustion strategy of such converted diesel engines should advance and optimize the mass of fuel that burns inside the squish region.

Investigations of a Gas Turbine Low-Emission Combustor Operating on the Synthesis Gas

Methodology to Separate the Two Burn Stages of Natural-Gas Lean Premixed-Combustion Inside a Diesel Geometry

Lessons from the Conversion of a Heavy-Duty Compression Ignition Engine to Natural Gas Spark Ignition Operation

Optical and Numerical Investigations of Flame Propagation in a Heavy Duty Spark Ignited Natural Gas Engine

Analysis of Two-Stage Natural-Gas Lean Combustion Inside a Diesel Geometry

Observation of Flame Propagation in a Heavy-Duty Natural-Gas Lean Burn Spark-Ignition Engine

Kinetics Modeling on NOx Emissions of a Syngas Turbine Combustor Using Rich-Burn, Quick-Mix, Lean-Burn Combustion Method

Kinetics Modeling On Nox Emissions Of A Syngas Turbine Combustor Using Rql Combustion Method

Combustion Diagnostics and Emissions Measurements of a Novel Low Nox Burner for Industrial Gas Turbine Operated with Co2 Diluted Methane/Air Mixtures

Experimental Investigation on Combustion and Emission Characteristics of Rich-Burn/Quick-Quench/Lean-Burn (RQL)Combustor

Investigation of the Combustion Performance in a Three-Nozzle RQL Combustor

Lean Premixed and Low NO<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript> Combustor with Recirculation Ratio of Fuel Gas Controllable

Effect of Natural Gas Composition on Low Nox Burners Operation in Heavy Duty Gas Turbine

Lean Premixed And Low Nox Combustor With Recirculation Ratio Of Fuel Gas Controllable

Experimental Study of Flow Characteristic in Low NO_x Combustor with Controllable Flue Gas Recirculation

Geometry Optimization of a Commercial Annular RQL Combustor of a Micro Gas Turbine for Use with Natural Gas and Vegetal Oils

Improving Lifetime and Manufacturability of an Rql Combustor for Microturbines: Design and Numerical Validation

Combustion stage configurations for intercooled regenerative reheat gas turbine systems

Analysis of the Mixing and Emission Characteristics in a Model Combustor

Experimental Study Of Nitrogen Dilution Effects On A Double-Swirled Non-Premixed Syngas Burner

Design & Test of a Syngas Double-Swirled Non-Premixed Combustor in Gas Turbine