Emanuel F. S. Sampaio,Carmen S. D. Rodrigues,Vanessa N. Lima,Luis M. Madeira
Abstract:The present study assesses the treatability of a real industrial wastewater (WW) with a high organic load (chemical oxygen demand (COD) above 5800 mgO2 L−1) by photo-Fenton’s oxidation with the goal of improving the organic matter degradation reached previously, in another work, where the Fenton process was applied in a bubbling reactor. Thus, the process was carried out in a bubble photo reactor (BPR) wherein continuous air supply ensures an efficient mixing of the liquid phase. The effect of the main operatory parameters that influence the WW treatment (i.e., H2O2 and Fe2+ concentrations, initial pH, and UV-Vis radiation intensity) were evaluated, being found that in the best conditions tested (pH0 = 4.6, [Fe2+] = 0.1 g L−1, [H2O2] = 18 g L−1, Qair = 1.0 L min−1—measured at room temperature and atmospheric pressure—and irradiance of 500 W m−2), removals of 95% and 97% for total organic carbon (TOC) and COD, respectively, were achieved. Still, a high reduction of the concentration of the main constituents of this WW was reached, being total for aniline and 86% for sulfanilic acid. The continuous air supply reactor configuration was compared with magnetic stirring; similar mineralization was achieved. However, the air bubbling promotes a good heat transfer within the reactor, minimizing temperature gradients, which is quite advantageous due to the strong exothermicity of the oxidation process during the treatment of such highly loaded real effluents.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to deal with actual industrial wastewater containing high organic load (chemical oxygen demand (COD) exceeding 5,800 mgO₂/L). Specifically, the research aims to improve the efficiency of organic matter degradation through the photo - Fenton oxidation process, especially in the Bubble Photo Reactor (BPR) with continuous air - flow supply. The main operating parameters of concern in the study include the concentrations of hydrogen peroxide (H₂O₂) and ferrous ions (Fe²⁺), the initial pH value, and the ultraviolet - visible light radiation intensity. The goal of the study is to achieve the maximum removal rates of total organic carbon (TOC) and COD under the optimal conditions and to explore the advantages of the continuous air - flow supply configuration compared with magnetic stirring in treating this highly polluted industrial wastewater.
### Research Background
Industrial wastewater often contains harmful organic pollutants (HOPs), which are important sources of environmental pollution. Aromatic amine compounds (such as aniline and its derivatives) are common HOPs in industrial wastewater because these compounds are used to produce intermediate substances required for a variety of industries, such as rubber processing, dyes, pesticides, fiber manufacturing, and petroleum refining. Aromatic amines are toxic to microorganisms and plants and are carcinogenic and mutagenic. Therefore, when wastewater containing these compounds is discharged without proper treatment, it poses a potential threat to the environment and public health. Therefore, it is crucial to remove or at least reduce the concentrations of these compounds to meet the emission standards stipulated by regulations.
### Research Methods
The study used a 0.5 - liter - capacity cylindrical glass Bubble Photo Reactor equipped with an ultraviolet - visible light lamp. In the experiment, the pH value was adjusted, a catalyst (ferrous sulfate heptahydrate) was added, and an air - bubble supply was started. Samples were regularly collected to measure the pH value, temperature, and remaining H₂O₂ concentration, as well as to determine the total organic carbon (TOC) content. The experiment also evaluated chemical oxygen demand (COD), biochemical oxygen demand (BOD₅), toxicity, and biodegradability.
### Experimental Results
Under the optimal conditions (initial pH value of 4.6, [Fe²⁺] = 0.1 g/L, [H₂O₂] = 18 g/L, air - flow rate of 1.0 L/min, and irradiation intensity of 500 W/m²), a 95% TOC removal rate and a 97% COD removal rate were achieved. In addition, the concentration of the main component such as aniline was completely removed, and the concentration of sulfanilic acid was reduced by 86%. Compared with magnetic stirring, although the degree of mineralization in the reactor configuration with continuous air - flow supply was similar, bubble stirring promoted good heat transfer in the reactor and reduced the temperature gradient, which was particularly advantageous for treating this highly polluted actual wastewater.
### Conclusion
The study shows that photo - Fenton oxidation treatment using a Bubble Photo Reactor with continuous air - flow supply is an efficient technique that can significantly improve the degradation efficiency of organic matter and the biodegradability of wastewater. This finding is of great significance for treating industrial wastewater with high organic load.